Rodrigo Martins

High quantum efficiency, UV-enhanced monocrystalline zinc sulphide optical sensors for precise radiometric and spectroscopic measurements have been developed by spray deposition of heavy fluorinedoped tin oxide thin films with carrier concentration near 1021 cm-3 onto the surface of zinc sulphide monocrystals as an alternative to the UV-enhanced silicon photodetectors as well as to new detectors based on SiC and GaN. The fabricated sensors have an unbiased internal quantum efficiency that was nearly 100% from 250 to 320 nm, and the typical sensitivity at 290 nm is 0.15 A/W. The sensors were insensitive to solar radiation in earth's conditions and can be used as solar blind photodetectors for precision UV-measurements under direct solar illumination, both terrestrial and space applications.

From the flying spot technique (FST) the ambipolar diffusion length and the effective-lifetime of the carriers photogenerated by a moving light spot that strikes a p-i-n junction can be inferred. In this paper, those properties of a p-i-n junction are used together with an optical triangulation principle to determine the velocity of an object that is moving in the direction of a light source. The light reflected back from the object is analysed through an amorphous or a microcrystalline p-i-n structure. Its transient transverse photovoltage is dependent on the velocity of the object. A comparison between the performances of both kinds of devices is presented.

Wide band gap microcrystalline silicon films have aroused considerable interest since they combine some electro-optical advantages of amorphous and crystalline materials highly important to produce electro-optical devices such as TFTs and solar cells. In this paper we present results concerning the electro-optical characteristics of highly transparent and conductive n-type μc-Si based films. Here, emphasis is given to the production of n-type μc-films with optical gaps of 2.3 eV and dark conductivity's of 6.5 Scm-1.

The influence of different TCOs (SnO2 and ITO) on the photoelectrical properties of 1-D position sensitive detectors based on p-i-n structures was studied. A strong cross-contamination in the p-layer and contamination in the i-layer reduce the quality of the device. Numerical analysis of TCO/p-i-n structure also revealed a strong increase in defect states at the p-layer surface which can be attributed to the reduction of TCO. ITO seems to be less appropriate for a front TCO, although the spectral response of the p-i-n structure under reverse bias is not significantly affected by the conditions at the TCO/p heterojunction.

A Linear array Thin Film Position Sensitive Detector (LTFPSD) based on hydrogenated amorphous silicon (a-Si:H) is proposed for the first time, taking advantage of the optical properties presented by a-Si:H devices we have developed a LTFPSD with 128 integrated elements able to be used in 3D inspections/measurements. Each element consists on a 1D LTFPSD, based on a p.i.n. diode produced in a conventional PECVD system, where the doped layers are coated with thin resistive layers to establish the required device equipotentials. By proper incorporation of the LTFPSD into an optical inspection camera it will be possible to acquire information about an object/surface, through the optical cross- section method. The main advantages of this system, when compared with the conventional CCDs, are the low complexity of hardware and software used and that the information can be continuously processed (analogue detection).

This work presents the main static and dynamic performances showed by one dimensional thin film position sensitive detectors (1D TFPSD), based on a-Si:H technology, with a size of 80 mm × 5 mm. The results obtained show that the TFPSD is able to respond to light powers as low as 2μ W/cm2, presenting a detection accuracy, linearity and response frequency better than 10 μm, 2% and 2 KHz, respectively. These results are quite promising regarding the application of these sensors to a wide variety of optical inspection systems where continuous quality control is required.

In this paper we present a study on the electrical characteristics (conductivity, σ and relative dielectric constant, εr) of amorphous silicon nitride (a-SixN1-x) and carbide (a-SixC1-x) films deposited by PECVD, used as dielectric materials in TFT devices, aiming to select the most adequate alloy that lead to improve device performances. Besides that, double stack a-SixN1-x/a-SixC1-x structures were developed and applied as dielectric layers on TFTs, whose performances show to be superior to those ones using single silicon nitride or silicon carbide as dielectric.

The use of ITO thin films on glass/ITO/p-i-n/metal amorphous silicon solar cells is reviewed. It is suggested a new application for silicon monoxide thin films on the ITO-p interface, as an intermediate layer, to minimize the ITO thin film deterioration process, during the early stage of exposure to a silane plasma rich in hydrogen. The thickness of the silicon monoxide thin films is chosen not to worsen the optical and electrical properties of the ITO thin films. The ITO-p interface is optimized (due to impurities diffusion decrease), leading to an overall improvement of the device performance.

The use of ITO films on glass/ITO/p-i-n/metal amorphous silicon solar cells is reviewed. It is suggested a new application for silicon monoxide thin films on the ITO-p interface, as an intermediate layer, to minimize the ITO thin film deterioration process, during the early stage of exposure to a silane plasma rich in hydrogen. The thickness of the silicon monoxide thin films is chosen not to worsen the optical and electrical properties of the ITO thin films. The ITO-p interface is optimized (due to impurities diffusion decrease), leading to an overall improvement of the device performance.

In this work, we present a model to interpret the steady-state and the dynamic detection limits of 1-D Thin Film Position Sensitive Detectors (1-D TFPSD) based on p-i-n a-Si:H devices. From this, an equivalent electric circuit is derived and the predicted values are compared with the experimental results obtained in 1-D TFPSD devices, with different sizes. The model is also able to determine the device characteristics that influence the spatial limits and the response time of the device. © 1996 IEEE.

The objective of this work is to provide a basis for the interpretation of the a-Si:H photodiode behaviour under low illumination level conditions, where a lateral leakage current plays an important role on the devices' performances when the doped collecting layer can not be considered a true equipotential. To determine this effect, a-Si:H p.i.n devices with small metal dot contacts, matrix distributed, were produced and analysed before and after etching the surrounding doped region of the metal collecting contact. The experimental data fit a model that includes the contribution of a lateral leakage current influencing the J-V characteristics, responsivity and the apparent light degradation behaviour of the device.

A novel compact linear thin film position sensitive detector with 128 elements, based on p-i-n a-Si:H devices was developed. The proper incorporation of this sensor into an optical inspection camera makes possible the acquisition of three dimension information of an object, using laser triangulation methods. The main advantages of this system, when compared with the conventional charge-coupled devices, are the low complexity of hardware and software used and that the information can be continuously processed (analogue detection).

Results are presented which are geared towards an understanding of the influence of powder formation during film growth. Plasma chemistry is correlated with the morphology, structure (inferred through infrared spectroscopy, scanning electron microscopy and X-ray diffraction) electro-optical and density of states of intrinsic films deposited under continuous and power modulated operation. Results show that for modulation frequencies where no powder formation occurs and low substrate temperatures T (150°C), silane decomposition gives rise to the growth of inhomogeneous films while in the high modulation frequency regime, at the same temperature, the anions and powder are trapped resulting in films with high deposition rates and low defect density.

To determine self-consistently the time evolution of particle size and their number density in situ multi-angle polarization-sensitive laser light scattering was used. Cross-polarization intensities (incident and scattered light intensities with opposite polarization) measured at 135° and ex situ transmission electronic microscopy analysis demonstrate the existence of nonspherical agglomerates during the early phase of agglomeration. Later in the particle time development both techniques reveal spherical particles again. The presence of strong cross-polarization intensities is accompanied by low-frequency instabilities detected on the scattered light intensities and plasma emission. It is found that the particle radius and particle number density during the agglomeration phase can be well described by the Brownian free molecule coagulation model. Application of this neutral particle coagulation model is justified by calculation of the particle charge whereby it is shown that particles of a few tens of nanometer can be considered as neutral under our experimental conditions. The measured particle dispersion can be well described by a Brownian free molecule coagulation model including a log-normal particle size distribution. © 1996 American Institute of Physics.

This paper presents a low-cost technology for the realisation of large-area thin film position-sensitive detectors using the a-Si:H technology. The obtained results are quite promising regarding the application of these sensors to a wide variety of optical inspection systems, such as: machine tool alignment and control; angle measuring; rotation monitoring; surface profiling; medical instrumentation; targeting; remote optical alignment; guidance systems; etc., to which automated inspection control is needed.

The aim of this work is to present an analytical model able to interpret the role of the thin collecting resistive layer on the static performances exhibited by 1D amorphous silicon hydrogenated p-i-n thin film position sensitive detectors. The data obtained show that the devices present a linearity and a spatial resolution, of respectively, better than 99% and 20 μm for a spatial detection limit of about 80 mm, highly dependent on the characteristics exhibited by the collecting resistive layer that should have sheet resistivities in the range of 10 to 103 Ω/sq, as predicted by the model proposed. © 1996 American Institute of Physics.

The aim of this work is to present a model to interpret the static and the dynamic detection and resolution limits of 1D thin film position sensitive detectors based on p-i-n a-Si:H devices. The model can determine the device characteristics that influence the spatial limits and the response time of the device.

This paper presents results of the role of the oxygen partial pressure used during the deposition process on the transport properties exhibited by doped microcrystalline silicon oxycarbide films produced by a Two Consecutive Decomposition and Deposition Chamber system, where a spatial separation between the plasma and the growth regions is achieved. This paper also presents the interpretative models of the optoelectronic behaviour observed in these films (highly conductive and transparent with suitable properties for optoelectronic applications) as well as the interpretation of the growth process that leads to film's microcrystallization.

We present here a two-dimensional numerical simulation of a hydrogenated amorphous silicon p-i-n solar cell non-uniformly illuminated through the p-layer. This simulation is used to show the effect of the presence of dark regions in the illuminated surface on the electrical behaviour of the device. The continuity equations for holes and electrons together with Poisson's equation, implemented with a recombination mechanism reflecting the amorphous structure of the material, are solved using standard numerical techniques over a rectangular domain. The results obtained reveal the appearance of a lateral component of the electric field and current density vectors inside the structure. The effect of such components is a lateral carrier flow of electrons inside the intrinsic layer and of holes inside the p-layer, resulting in leakage of the transverse current collected at the contacts and an increase in the series resistance.

The aim of this work is to provide the basis for the interpretation, under steady state and in the low-voltage regime of the dark current-density-voltage (J-V) characteristics of transverse asymmetric amorphous silicon (a-Si:H) p-i-n and n-i-p diodes. The transverse asymmetric a-Si:H diodes present ratios between the metal contact and the underneath doped layer areas larger than five, leading to the inclusion, in the diode equation, of a lateral leakage current, responsible for the high saturation current density and the forward shape of the J-V curves recorded. The leakage current depends on the lateral spatial potential developed with which varies following a power-law dependence. The experimental J-V curves in diodes with the doped layer around the metal contact unetched and etched prove the role and origin of this lateral leakage current and, thus, the proposed model. © 1995 American Institute of Physics.

The aim of this work is to provide the basis for the interpretation of the steady state lateral photoeffect observed in p-i-n a-Si:H 1D Thin Film Position Sensitive Detectors (1D TFPSD). The experimental data recorded in 1D TFPSD devices with different performances are compared with the predicted curves and the obtained correlation's discussed.

The aim of this work is to present the main optoelectronic characteristics of large area 1D position sensitive detectors based on amorphous silicon p-i-n diodes. From that, the device resolution, response time and detectivity are derived and discussed concerning the field of applications of the 1D thin film position sensitive detectors.

In the past we have developed a transient technique, called the Flying Spot Technique (FST). FST allows, not only to infer the ambipolar diffusion length but also the effective lifetime of the photogenerated carriers once the light spot velocity and geometry of the structure were known. In this paper, we propose to apply this technique backwards in order to detect the path and velocity of an object that is moving in the direction of a light source. The light reflected back from the object is analyzed through a p.i.n structure being the transient transverse photovoltage dependent on the movement of the object (position and velocity). Assuming that the transport properties of the material and the geometry of the device are known and using a triangulation method we show that it is possible to map the movement of the object. Details concerning material characterization, simulation and device geometry are presented.

PIN devices based on hydrogenated amorphous silicon (a-Si:H) became fundamental elements of many different types sensors, based on either the transverse or the lateral photovoltaic effect. In the past we have developed a transient technique, called the Flying Spot Technique (FST), based on the lateral photoeffect. FST allows, not only to infer the ambipolar diffusion length but also the effective lifetime of the photogenerated carriers once the light spot velocity and geometry of the structure were known. In this paper we propose to apply this technique backwards in order to detect the path and velocity of an object that is moving in a light source direction. The light reflected back from the object is analyzed through p.i.n. structure being the transient transverse photovoltage dependent on the object movement (position and velocity). Assuming known the transport properties of the material and the geometry of the device and using a triangulation method we show that it is possible to map the object movement. Details concerning material characterization, simulation and device geometry are presented.

The aim of this work is to present the main optoelectronic characteristics of large-area one-dimensional position-sensitive detectors (1D TFPSDs) based on amorphous silicon (a-Si) p-i-n diodes. From that, the device resolution, response time and detectivity (defined as being the reciprocal of the noise equivalent power pattern) are derived and discussed concerning the field of applications of the 1D TFPSDs. © 1996.