The thermal decompositions of methyl azidoformate (N3COOMe), ethyl azidoformate (N3COOEt) and 2-azido-N,N-dimethylacetamide (N3CH2CONMe2) have been studied by matrix isolation infrared spectroscopy and real-time ultraviolet photoelectron spectroscopy. N2 appears as an initial pyrolysis product in all systems, and the principal interest lies in the fate of the accompanying organic fragment. For methyl azidoformate, four accompanying products were observed: HNCO, H2CO, CH2NH and CO2, and these are believed to arise as a result of two competing decomposition routes of a four-membered cyclic intermediate. Ethyl azidoformate pyrolysis yields four corresponding products: HNCO, MeCHO, MeCHNH and CO2, together with the five-membered-ring compound 2-oxazolidone. In contrast, the initial pyrolysis of 2-azido-N,N-dimethyl acetamide, yields the novel imine intermediate Me2NCOCHNH, which subsequently decomposes into dimethyl formamide (HCONMe2), CO, Me2NH and HCN. This intermediate was detected by matrix isolation IR spectroscopy, and its identity confirmed both by a molecular orbital calculation of its IR spectrum, and by the temperature dependence and distribution of products in the PES and IR studies. Mechanisms are proposed for the formation and decomposition of all the products observed in these three systems, based on the experimental evidence and the results of supporting molecular orbital calculations.

The thermal decompositions of methyl azidoformate (N3COOMe), ethyl azidoformate (N3COOEt) and 2-azido-N,N-dimethylacetamide (N3CH2CONMe2) have been studied by matrix isolation infrared spectroscopy and real-time ultraviolet photoelectron spectroscopy. N2 appears as an initial pyrolysis product in all systems, and the principal interest lies in the fate of the accompanying organic fragment. For methyl azidoformate, four accompanying products were observed: HNCO, H2CO, CH2NH and CO2, and these are believed to arise as a result of two competing decomposition routes of a four-membered cyclic intermediate. Ethyl azidoformate pyrolysis yields four corresponding products: HNCO, MeCHO, MeCHNH and CO2, together with the five-membered-ring compound 2-oxazolidone. In contrast, the initial pyrolysis of 2-azido-N,N-dimethyl acetamide, yields the novel imine intermediate Me2NCOCHNH, which subsequently decomposes into dimethyl formamide (HCONMe2), CO, Me2NH and HCN. This intermediate was detected by matrix isolation IR spectroscopy, and its identity confirmed both by a molecular orbital calculation of its IR spectrum, and by the temperature dependence and distribution of products in the PES and IR studies. Mechanisms are proposed for the formation and decomposition of all the products observed in these three systems, based on the experimental evidence and the results of supporting molecular orbital calculations.

Pseudoazurin binds at a single site on cytochrome c peroxidase from Paracoccus pantotrophus with a K-d of 16.4 muM at 25 degreesC, pH 6.0, in an endothermic reaction that is driven by a large entropy change. Sedimentation velocity experiments confirmed the presence of a single site, although results at higher pseudoazurin concentrations are complicated by the dimerization of the protein. Microcalorimetry, ultracentrifugation, and H-1 NMR spectroscopy studies in which cytochrome c550, pseudoazurin, and cytochrome c peroxidase were all present could be modeled using a competitive binding algorithm. Molecular docking simulation of the binding of pseudoazurin to the peroxidase in combination with the chemical shift perturbation pattern for pseudoazurin in the presence of the peroxidase revealed a group of solutions that were situated close to the electron-transferring heme with Cu-Fe distances of about 14 Angstrom. This is consistent with the results of H-1 NMR spectroscopy, which showed that pseudoazurin binds closely enough to the electron - transferring heme of the peroxidase to perturb its set of heme methyl resonances. We conclude that cytochrome c550 and pseudoazurin bind at the same site on the cytochrome c peroxidase and that the pair of electrons required to restore the enzyme to its active state after turnover are delivered one-by-one to the electron-transferring heme.

n/a

n/a

n/a

The main aim of the Valomat project was the development of new materials for quarry back-filling and underground constructions, based on the reuse of bottom ashes from MSWI. Bottom ashes were collected in six incineration plants of Europe. Some of them were selected for the development of new materials.
One task of this project comprised the study of the long-term behavior of new materials, under simulated conditions of environmental exposure. Three different scenarios were studied. For each scenario, a pilot plant was constructed and the new materials were studied under laboratory conditions or natural weather. The long-term behavior of these materials was assessed through the characterization of chemical and ecotoxicological properties of the leachates.
The chemical contamination and the ecotoxicological levels of the leachates were relatively low, although different levels had been determined for the three different scenarios. The immersion in dechlorinated tap water (scenario S1) had shown the highest emission levels of chlorides, sulphates, DOC, and Al, especially for the materials B2/1 and B2/2. The lowest ecotoxicological and chemical levels were determined in the scenario in which the materials were buried in a sieved soil.

n/a

n/a

n/a

n/a

n/a

n/a

Polymorphous silicon (pm-Si:H) films have been prepared by a new regime of plasma enhanced chemical vapour deposition in the region adjacent of phase transition from amorphous to microcrystalline state. Comparing to the conventional amorphous silicon (a-Si:H), the pm-Si:H has higher photoconductivity (σph), better stability, and a broader light spectral response range in the longer wavelength range. It can be found from Raman spectra that there is a notable improvement in the medium range order. There are a blue shift for the stretching mode of IR. spectra and a red shift for the wagging mode. The shifts are attributed to the variation of the microstructure. By using pm-Si:H film as intrinsic layer, a p-i-n junction solar cell was prepared with the initial efficiency of 8.51% and a stabilized efficiency of 8.01% (AM1.5, 100mw/cm2) at room temperature (T R).

n/a

A series of hydrogenated amorphous silicon carbide films were prepared by plasma enhanced chemical vapor deposition (PECVD) using a gas mixture of silane, methane, and hydrogen as the reactive source and an excitation frequency of 27.12 MHz. Compared to the typical radio frequency deposition technique, the very high plasma excitation frequency increases the density of the electrons and decreases the electron temperature, which helps the dissociation of the SiH4 and CH4, and reduces the energetic ion impact on the growth surface of the thin film. Thus, dense-films with lower bulk density of states and higher growth rate are expected, as confirmed by spectroscopic ellipsometry data. Apart from that, a substantial reduction of bulk defects is achieved, allowing an improvement of the valence controllability (widening of the optical gap from about 1.9 to 3.6 eV). In this work results concerning the microstuctural and photoelectronic properties of the silicon carbide films will be discussed in detail, correlating them with the deposition process conditions used as well as with the gas phase composition of the mixtures used. © 2004 Elsevier B.V. All rights reserved.

n/a

n/a

The aim of this paper is to compare the density of bulk states (DOS) of polymorphous silicon (pm-Si:H) films produced by plasma enhanced chemical vapor deposition at 13.56 and 27.12 MHz using the constant photocurrent method and the space charge limited current (SCLC) technique. The data achieved revealed that the set of films produced present similar DOS. Apart from that, data concerning the correlation of the deposition conditions that lead to the production of pm-Si:H as well as their characteristics, such as the hydrogen content and how hydrogen is bonded, will be discussed, giving special emphasis to the set of mechanical stresses developed. By doing so we could get a better understanding of the nature of hydrogen bonding in pm-Si:H films as well as to determine the role of the excitation frequency on the film's performances, where films with amounts of hydrogen around 20 at.% can have DOS as low as 8 × 10 14 cm-3 with Urbach energies in the range of 41-50 meV. © 2004 Elsevier B.V. All rights reserved.

n/a

n/a

Polyethylene is one of the most widely used polymeric insulators in medium and high voltage power cables. However the importance of space charge distribution and its influence on the electrical aging in this polymer is not fully understood. The very good insulating properties of the material implying very long relaxation times (few days and even longer are usual) and low currents (few pA or below) make individual measurements of isothermal charge/discharge currents and thermostimulated currents difficult to analyze and reproduce. A single type of measurements does not take into account the space charge that remains trapped for long times. A combined procedure of isothermal and non-isothermal current measurements developed for high insulating polymers was used for low density polyethylene (LDPE) and crosslinked polyethylene (XLPE) films electrically aged. The press-molded LDPE and XLPE films were electrically aged under similar conditions using an AC electric field while immersed in a sodium chloride aqueous solution at constant temperature (electro-thermal aging). The use of the combined procedure for current measurement allowed obtaining information about space charge traps, activation energies and relaxation times for both LDPE and XLPE. This data was used to compare electrical aging under similar conditions for the two types of polyethylene.