n/a

Conversion of Fe ions in solution to the solid phase in ferritin concentrates iron required for cell function. The rate of the Fe phase transition in ferritin is tissue specific and reflects the differential expression of two classes of ferritin subunits (H and L). Early stages of mineralization were probed by rapid freeze-quench Mossbauer, at strong fields (up to 8 T), and EPR spectroscopy in an H-type subunit, recombinant frog ferritin; small numbers of Fe (36 moles/mol of protein) were used to increase Fe3+ in mineral precursor forms, At 25 ms, four Fe3+-oxy species (three Fe dimers and one Fe trimer) were identified, These Fe3+-oxy species were found to form at similar rates and decay subsequently to a distinctive superparamagentic species designated the ''young core.'' The rate of oxidation of Fe2+ (1026 s(-1)) corresponded well to the formation constant for the Fe3+- tyrosinate complex (920 s(-1)) observed previously [Waldo, G. S., & Theil, E. C. (1993) Biochemistry 32, 13261] and, coupled with EPR data, indicates that several or possibly all of the Fe3+-oxy species involve tyrosine. The results, combined with previous Mossbauer studies of Y30F human H-type ferritin which showed decreases in several Fe3+ intermediates and stabilization of Fe2+ [Bauminger, E. R., et al. (1993) Biochem, J. 296, 709], emphasize the involvement of tyrosyl residues in the mineralization of H-type ferritins. The subsequent decay of these multiple Fe3+-oxy species to the superparamagnetic mineral suggests that Fe3+ species in different environments may be translocated as intact units from the protein shell into the ferritin cavity where the conversion to a solid mineral occurs.

The objective of this work is to present an analytical model able to interpret the experimental dependence of the uniformity of films produced by the plasma-enhanced chemical vapour deposition technique on the deposition parameters (discharge pressure, gas flow temperature and rf power density). The model proposed is based on the Navier-Stokes equations applied to a gas flow considered to be quasi-incompressible and quasi-inviscous, whenever the Mach number is below 0·3. This condition leads to the establishment of the proper quasisteady-state gas flow equations, and the corresponding equations of energy and momentum balance ascribed to the mass profile of the species formed, under the presence of a low-rf-power plasma density, are able to predict the uniformity distribution of the film over the entire deposited substrate area.

The aim of this work is to present an analytical model able to interpret the experimental data of the dependence of film's uniformity on the discharge pressure, gas flow and temperature used during the production of thin films by the plasma enhancement chemical vapour deposition technique, under optimised electrode's geometry and electric field distribution. To do so, the gas flow is considered to be quasi-incompressible and inviscous leading to the establishment of the electro-fluid-mechanics equations able to interpret the film's uniformity over the substrate area, when the discharge process takes place in the low power regime.

The magnitude of the time autocorrelation function M between states excited by two Gaussian laser pulses is calculated for both hydrogen and rubidium atoms inparallel electric and magnetic fields. M is determined by a full quantum-mechanical calculation but the peaks are identified with the periods of the shortest periodicorbits of the corresponding classical system. Qualitative agreement is obtained with experimental results, however, discrepancies are found in the relative heights ofthe peaks.

n/a

The aim of this work is to present an analytical model able to interpret the role of the thin collecting resistive layer on the static performances exhibited by 1D amorphous silicon hydrogenated p-i-n thin film position sensitive detectors. The data obtained show that the devices present a linearity and a spatial resolution, of respectively, better than 99% and 20 μm for a spatial detection limit of about 80 mm, highly dependent on the characteristics exhibited by the collecting resistive layer that should have sheet resistivities in the range of 10 to 103 Ω/sq, as predicted by the model proposed. © 1996 American Institute of Physics.

The aim of this study was to evaluate the possibility of the re-use of industrial orange wastes as organic soil fertilizer. The assay was performed with a lettuce variety widely produced and consumed in Portugal and, consequently, with great commercial interest. Lactuca sativa L. (osteolata variety) was cultivated in Mitcherlich pots containing samples of a poor soil of the Algarve region. This soil was prepared with different amounts of either pulp or peel orange-wastes from an orange-juice industry. The wastes were applied according to an increasing amount of nitrogen. The results obtained were submitted to statistical tests, in order to find the relations between the production of fresh and dry matter, and the percentages of nutrients (nitrogen, phosphorous, potassium, calcium, magnesium and iron) that were obtained in the dry matter, with the types and amounts of wastes applied. An increase in the average production of both fresh- and dry-matter with increasing amounts of either pulp or peel wastes applied, and high positive correlation coefficients between the average percentages of nitrogen, phosphorus and potassium obtained in the dry matter with the average production of both fresh- and dry-matter were found. No phytotoxicity was observed.

n/a

The aim of this work is to present experimental data concerning the role of the oxygen partial pressure during the production process on the properties (structure, morphology, composition, and transport properties) exhibited by doped microcrystalline silicon oxycarbide films. The films were produced by a two consecutive decomposition and deposition chamber system, where a spatial separation between the plasma and the growth regions is achieved. The films produced by this technique are highly conductive and highly transparent with suitable properties for optoelectronic applications requiring wide band-gap and low-conductivity materials. © 1995, American Vacuum Society. All rights reserved.

The aim of this work is to interpret the role of the lateral leakage current on the a-Si:H solar cell performances (J-V characteristics, responsivity and the apparent device degradation behaviour), under low illumination conditions.

PIN solar cells were light soaked up to 60 hours. The cell characteristics, the optoelectronic properties and the microstructure parameter (R = I2100/I2100+I2000) as well as the hydrogen content (CH) and density of states (g(Ef)) of the active i-layer were monitored throughout the entire light induced degradation process and compared with the correspondents μτ product (for both carriers) inferred through steady photoconductivity and FST measurements. Data show a strong correlation between the decrease of μτ product for electron and the increase of the fraction of hydrogen bonded on internal surfaces (R increases from 0.1 to 0.4) suggesting structural changes during the light induced defects' formation. For holes, the μτ product remains approximately constant and only dependent on the initial hydrogen content. As g(Ef) increases, μτ presents an asymmetrical decrease showing that electrons are more sensitive to defects' growth than holes. We also observe that the rate of degradation is faster for samples having the lowest defect densities, R and CH, showing that the amount of degradation is not a simple function of the photon exposure (Gt product) but also depends on the material microstructure.

Industrial rationalization represents a decisive moment of the strategic development of business activities in the last few years. In this sense, it is also a theoretical challenge to Industrial Sociology, since the dimensions, both technical and social, of that rationalization can be underlined. The analysis of the better-known different patterns of rationalization allows us a further knowledge of the main strategies for industrial modernization. Accordingly, this paper presents some results deriving from the application of those strategies. Finally, this paper gives a particular attention to the more recent tendencies of development of integrated systems of production, particularly of those focusing upon the social and organizational aspects of industrial rationalization.