The self-assembly of Ag[BF(4)] with trans-azobenzene in dichloromethane yields a new coordination polymer ([Ag(mu -trans-azobenzene)H(2)O] [BF(4)])(n) which was characterized by X-ray single crystal diffraction. The crystal consists of 1-D zigzag cationic chains made up from [Ag(H(2)O)](+) units linked by trans-azobenzene bridges and BF(4)(-) anions. Hydrogen bonding interactions between the chains and BF(4)(-) anions occur via intermolecular C-H . . .F and O-H . . .F contacts, and the crystal displays a 2-D supramolecular structure.

This paper summarises the methodological approach and main results of the MARHE project (Employment and Human Resources in the Fisheries Socio-Economic System). This project had as its main aim the search for alternative futures for the fisheries sector in Portugal, with particular attention being paid to the human resources situation and the working and living conditions of the fisheries-dependent populations in the coastal areas. This is a particularly interesting case, since fisheries were once an important activity and they are now in deep recession, even though it is generally recognised that the future utilisation of maritime resources offer an immense potential. As part of the research, a Delphi exercise was implemented involving in two successive stages some of the leading actors and experts dealing with the sector in Portugal. Other initiatives were held in the context of the MARHE project providing direct and indirect inputs to the scenarios and recommendations that were put forward in the sequence of the Delphi exercise. Overall the activities described in the paper contributed to the mobilisation of major actors and to discussions that may have practical implication for the future of the sector, if certain conditions are now met in the follow up to the project.

The role of the deposition pressure (p) and the type of filaments (tungsten, W or tantalum, Ta) used to produce large area (10cm×10cm) n-type Si:H films by hot wire chemical vapour (HW-CVD) deposition technique was investigated. The data show that the electro-optical properties of the films produced are dependent on the gas pressure used. In the pressure range of 1×10-3 Torr to 1.0 Torr, the room dark conductivity (σd) varies from 1×10-8 to 2 S/cm for films produced at the same hydrogen dilution and filament temperature (Tfil). On the other hand, the hydrogen concentration (CH) decreases from 10% to 2%, while the growth rate (R) shows an exponential increase, from 1 to 9 Å/s. The SIMS analysis, within the detection limits, does not reveal the existence of any significant W or Ta contamination in the films produced.

In this work, we show results concerning electro-optical properties, composition and morphology of nanocrystalline hydrogenated undoped silicon (nc-Si:H) films produced by hot wire plasma assisted chemical vapour deposition process (HWPA-CVD) and exhibiting a compact granular structure, as revealed by SEM micrographs. This was also inferred by infrared spectra, which does not present the SiO vibration band located at 1050-1200 cm-1, even when samples have long atmospheric exposition. The photoconductivity measured at room temperature also does not change when samples have a long time exposition to the air or to the light irradiation. The influence of hydrogen dilution on the properties of the films was also investigated.

In this paper the influence of the DC grid bias on the plasma impedance and the I-V behaviour of silane plasmas used to grow undoped amorphous silicon films by plasma enhanced chemical vapour deposition technique using a triode configuration at or close to the powder regime is studied. The aim is to determine the correlation between the r.f. power and the DC grid voltage with the plasma parameters, under isothermal gas conditions. The results should lead to the production of nanostructured films, with the required optoelectronic characteristics for photovoltaic applications. The results achieved show the existence of a boundary region close to the γ-regime (powder formed) where nanoparticles can be formed by moderated ion bombardment of the growing surface. This is characterised by the plasma resistance of the same order of magnitude of the plasma reactance. Under this condition, it is possible to grow amorphous silicon films that can incorporate nanoparticles, exhibiting photosensitivities of about 107 (two orders of magnitude larger than the one exhibited by films grown under conventional conditions) with densities of states determined by the constant photocurrent method below 3 × 1015 cm3. Apart from that, the growth of the films is less affected by light soaking than the conventional films grown by standard techniques. © 2001 Elsevier Science Ltd. All rights reserved.

In this paper we report on large area one dimensional (1D) amorphous silicon position sensors deposited on flexible polymer foil substrate. The pin sensor structure was deposited by rf plasma enhanced chemical vapour deposition (PECVD). For the electrical and optical characterisation the sensors have been mounted on a convex holder with a 14-mm radius-of-curvature, since the main goal of this work is to develop a flexible position sensor to be incorporated in a micromotor in order to measure its angular velocity continuously. The obtained sensors present adequate performances concerning the position non-linearity (±1% in 20 mm length), comparable to those fabricated on glass substrates. © 2000 Elsevier Science B.V. All rights reserved.

Nitrous oxide (N(2)O) is a greenhouse gas, the third most significant contributor to global warming. As a key process for N(2)O elimination from the biosphere, N(2)O reductases catalyze the two-electron reduction of N(2)O to N(2). These 2 x 65 kDa copper enzymes are thought to contain a CuA electron entry site, similar to that of cytochrome c oxidase, and a CuZ catalytic center. The copper anomalous signal was used to solve the crystal structure of N(2)O reductase from Pseudomonas nautica by multiwavelength anomalous dispersion, to a resolution of 2.4 Angstrom. The structure reveals that the CuZ center belongs to a new type of metal cluster, in which four copper ions are liganded by seven histidine residues. N(2)O binds to this center via a single copper ion. The remaining copper ions might act as an electron reservoir, assuring a fast electron transfer and avoiding the formation of dead-end products.

Presacral vertebrae of a new Diplodocidae from the Late Jurassic Amoreira-Porto Novo Formation of Lourinhã, Portugal are described and figured. Dinheirosaurus lourinhanensis gen. et sp. is diagnosed by well developed accessory articulations derived from the hyposphene, exposed in lateral view; and by the smaller dorsoventral length of the lower section of the neural arch. It is considered that the organization of the dorsal neural arch of Dinheirosaurus is more derived than in Diplodocus, except in the dorsoventral development of the lower portion of it, which is higher (more derived) in the latter. Possibly the isolated geography of Portugal in the Late Jurassic gave rise to the distinct characters of this new genus.

The numerical implementation of the displacement model of the hybrid-{T}refftz finite element formulation is presented. The geometry of the supporting element is not constrained a priori. Unbounded, non-convex and multiply connected elements can be used. The approximation basis is naturally hierarchical and very rich. It is constructed on polynomial solutions of the governing differential equation, and extended to include the particular terms known to model accurately important local effects, namely the singular stress patterns due to cracks or point loads. Numerical and semi-analytical methods are used to compute the finite element matrices and vectors, all of which present boundary integral expressions. Appropriate procedures to store, manipulate and solve symmetric highly sparse systems are used. The characteristics of the finite element solving system in terms of sparsity and conditioning are analysed, as well as its sensitivity to the effects of mesh distortion, incompressibility and rotation of the local reference systems. Benchmark tests are used also to illustrate the performance of the element in the estimation of displacements, stresses and stress intensity factors.

In this work we present data concerning the structure, composition and electro-optical performances of nanocrystalline silicon carbide doped films produced at the different filament temperatures and hydrogen dilution ratios. The XRD spectra reveal the presence of the typical Si peaks ascribed to (111) (220) and (311) diffraction planes, where no traces of the carbon peaks were found. The average grain sizes ranges from 10 nm to 30 nm, depending on the temperature of filament and hydrogen dilution used. We observed an enhancement of the peak ascribed to the (220) plane when high H dilution rates are used, meaning that the film starts being textured. The infrared data reveal the typical silicon carbide modes and a hydrogen content that varies from 3% to 1%, with the increase of the filament temperature. Besides that, the IR spectra show the typical SiO2 and SiO modes, associated to the oxide species that are mainly incorporated in the surface of the films and can be removed by proper wet etching. The planar conductivity is enhanced as the temperature of the filament is increased, being the highest conductivity achieved in the range of 0.2 (Ωcm)-1 and almost non activated. © 1998 Elsevier Science Ltd. All rights reserved.