Rodrigo Martins

In this paper we present results of indium doped zinc oxide deposited at room temperature by rf magnetron sputtering, with electron mobility as high as 60 cm2/Vs. The films present a resistivity as low as 5×10 -4 Ωcm with an optical transmittance of 85%. The structure of these films look-like polymorphous (mixed of different amorphous and nanocrystalline phases from different origins) as detected from XRD patterns (no clear peak exists) with a high smooth surface, as detected from SEM micrographs, highly important to ensure long life time when used in display devices.

Transparent and highly conducting gallium-doped zinc oxide films were successfully deposited by rf sputtering at room temperature. The lowest resistivity achieved was 2.6×10-4 Ω cm for a thickness of 1100 nm (sheet resistance ≈1.6 Ω/sq), with a Hall mobility of 18 cm2/Vs and a carrier concentration of 1.3×1021 cm-3. The films are polycrystalline with a hexagonal structure and a strongly preferred orientation along the c-axis. A linear dependence between the mobility and the crystallite size was obtained. The films present a transmittance in the visible spectra between 80 and 90% and a refractive index of approximately 2, which is very close to the value reported for bulk material. © 2003 Elsevier B.V. All rights reserved.

In this letter we compare the room temperature ozone sensing properties of intrinsic zinc oxide (ZnO) thin films deposited by spray pyrolysis, dc and r.f. magnetron sputtering. Their sensor response exceeds 8 orders of magnitude when the film structure is constituted by nanocrystallites. These preliminary results clearly demonstrate that the films could be potentially used for ozone detection at room temperature.

This work presents the I-V results of a-Si:H/SiOx/Pd MIS (metal-insulator-semiconductor) structures. The a-Si:H was deposited by non-conventional modified triode PECVD. This new configuration allows the deposition of high quality a-Si:H with a photosensitivity of 106, indicating the presence of low density of defects. Spectroscopic ellipsometry measurements revealed that these films are highly dense and present a very smooth surface so allowing a low defect interface between the Pd and the a-Si:H. As a result, we could make MIS photodiodes with barrier heights of 1.17 eV, which give a high reduction of the reverse dark current, an increase of the signal to noise ratio of 106 and an open circuit voltage VOC = 0.5 V. © 2002 Elsevier Science B.V. All rights reserved.

Transparent conducting ZnO:Al thin films have been deposited on polyester (Mylar type D, 100 μm thickness) substrates at room temperature by r.f. magnetron sputtering. The structural, optical and electrical properties of the deposited films have been studied. The samples are polycrystalline with a hexagonal wurtzite structure and a strong crystallographic c-axis orientation (002) perpendicular to the substrate surface. As deposited ZnO:Al thin films have an 85% transmittance in the visible and infra-red region and a resistivity as low as 3.6×10-2 Ωcm. The obtained results are comparable to those ones obtained on glass substrates, opening a new field for low cost, light weight, small volume, flexible and unbreakable large area optoelectronic devices.

We have produced amorphous intrinsic silicon thin films by hot-wire plasma assisted chemical vapor deposition, a process that combines the traditional rf plasma and the recent hot-wire techniques. In this work we have studied the influence of hydrogen gas dilution and rf power on the surface morphology, composition, structure and electro-optical properties of these films. The results show that by using this deposition technique it is possible to obtain at moderate rf power and filament temperature, compact i-type silicon films with ημτ of the order of 10 -5cm 2V -1, without hydrogen dilution. © 2002 American Institute of Physics.

In this work a new structure is proposed for position sensitive detectors consisting of glass/Cr/aSi:H(n+)/a-Si:H(i)/ZnO, where the ZnO forms an heterojunction with the a-Si:H(i). The results show that this structure works with success in the fabrication of linear position sensitive detectors. The devices present a good nonlinearity of ≈ 2% and a good sensitivity to the light intensity. The main advantages of this structure over the classical p-i-n are an easier to built topology and a higher yield due to a better immunity to the a-Si:H pinholes, since the ZnO does not diffuse so easily into a-Si:H as the metal does, which are the cause of frequent failure in the p-i-n devices due to short-circuits caused by the deposition of the metal over the a-Si:H. In this structure the illumination is made directly on the ZnO, so a transparent substrate is not needed and a larger range of substrates can be used.

Hydrogenated amorphous silicon photochemical sensors based on Pd-MIS structures were produced by Plasma Enhanced Chemical Vapor Deposition with two different oxidized surfaces (thermal and chemical oxidation). The behaviour of dark and illuminated current-voltage characteristics in air and in the presence of a hydrogen atmosphere is explained by the changes induced by the gases in the work function of the metal, modifying the electrical properties of the interface. The photochemical sensors produced present more than 2 orders of magnitude variation on the reverse dark current when in presence of 400 ppm hydrogen to which it corresponds a decrease of 45% on the open circuit voltage.

The aim of this paper is to present data on the dependence of the electro-optical characteristics and structure of n-type microcrystalline silicon films on the r.f. power used during the deposition of films produced by the plasma-enhanced chemical vapour deposition technique. The interest of these films arise from the fact that they combine some electro-optical advantages of amorphous (wide optical gap) and crystalline materials (electronic behaviour), highly interesting in the production of a wide variety of optoelectronic devices such as solar cells and thin film transistors. In this paper, microcrystalline n-type films presenting simultaneously optical gaps of about 2.3 eV, dark conductivity of 6.5 S cm-1 and Hall mobility of about 0.86 cm2 V-1 s-1 will be reported, the highest combined values for n-type microcrystalline silicon films, as far as we know. © 1997 Elsevier Science S.A.

The aim of this work is to present the main optoelectronic characteristics of large area 1D position sensitive detectors based on amorphous silicon p-i-n diodes. From that, the device resolution, response time and detectivity are derived and discussed concerning the field of applications of the 1D thin film position sensitive detectors.

In the past we have developed a transient technique, called the Flying Spot Technique (FST). FST allows, not only to infer the ambipolar diffusion length but also the effective lifetime of the photogenerated carriers once the light spot velocity and geometry of the structure were known. In this paper, we propose to apply this technique backwards in order to detect the path and velocity of an object that is moving in the direction of a light source. The light reflected back from the object is analyzed through a p.i.n structure being the transient transverse photovoltage dependent on the movement of the object (position and velocity). Assuming that the transport properties of the material and the geometry of the device are known and using a triangulation method we show that it is possible to map the movement of the object. Details concerning material characterization, simulation and device geometry are presented.

PIN devices based on hydrogenated amorphous silicon (a-Si:H) became fundamental elements of many different types sensors, based on either the transverse or the lateral photovoltaic effect. In the past we have developed a transient technique, called the Flying Spot Technique (FST), based on the lateral photoeffect. FST allows, not only to infer the ambipolar diffusion length but also the effective lifetime of the photogenerated carriers once the light spot velocity and geometry of the structure were known. In this paper we propose to apply this technique backwards in order to detect the path and velocity of an object that is moving in a light source direction. The light reflected back from the object is analyzed through p.i.n. structure being the transient transverse photovoltage dependent on the object movement (position and velocity). Assuming known the transport properties of the material and the geometry of the device and using a triangulation method we show that it is possible to map the object movement. Details concerning material characterization, simulation and device geometry are presented.

Undoped and doped hydrogenated amorphous silicon semiconductors (a-Si:H) have been produced by a two consecutive decomposition deposition chamber (TCDDC) system assisted by electromagnetic static fields. Through this technique, a spatial separation is achieved between the plasma chemistry and that of the deposition to avoid ion and electron (with high energies) bombardment on the growing surface. Besides this, the use of a static magnetic field perpendicular to the substrate will promote plasma confinement, so avoiding its contamination by residual gases adsorbed on the reactor walls. On the other hand, the use of two grids dc biased in the deposition chamber, will allow control of the main film precursors, responsible for the electro-optical and structural properties of deposited films. In this paper we shall discuss the deposition method used as well as the transport, structural and morphological properties presented by deposited films and its dependence on deposition parameters used. © 1989.

A double-chamber system was used to deposit large-area hydrogenated amorphous silicon films for photovoltaic applications. The electro-optical characterisation of films of area 400 cm2 deposited on glass substrates is described in this paper. The deposition rate of the films is dependent on the r.f. power delivered, the substrate bias and the partial pressure of the reactive gas. The film thickness was observed to have a uniformity of better than 0.5%. The best film quality was obtained for a deposition rate of about 1.5 Å s-1. The optical gap, activation energy, photosensitivity, density of gap states and hydrogen content were determined. © 1985.