Two self-buffer layers were grown on c-plane sapphire substrates by atmospheric MOCVD method using DEZn, tert-butanol as precursors and H 2 as carrier gas. Then, they were respectively annealed in growth process and oxygen environment. After that, ZnO films were respectively grown on them. XRD spectra show that all the films were grown in [002] orientation. Furthermore, the film with a buffer layer annealed in oxygen exhibits much higher crystal quality. Its FWHM of the rocking curve is only 567arcsec. Furthermore, its Raman scattering spectrum appears a much stronger E2 mode peak at 436cm-1 and its PL spectrum appears a shoulder at 3.367eV on the higher energy side. © 2006 WILEY-VCH Verlag GmbH & Co. KGaA,.

ZnO films with and without a self-buffer layer were grown on c-plane sapphire substrates by atmospheric metal organic chemical vapor deposition. The influence of the buffer layer thickness, annealing temperature and annealing time on ZnO films has been investigated. The full width at half maximum of the ω-rocking curve of the optimized self-buffer layer sample is only 395 arc sec. Its surface is composed of regular columnar hexagons. After the buffer layer was introduced, the A1 longitudinal mode peak at 576 cm- 1, related to the defects, disappears in Raman spectra. For the photoluminescence, besides the strong donor binding exciton peak at 3.3564 eV, an ionized donor binding exciton and a free exciton peak is respectively observed at 3.3673 and 3.3756 eV at the high-energy side in the spectrum of the sample with the buffer layer. © 2006 Elsevier B.V. All rights reserved.

Multicomponent amorphous oxides are starting to emerge as a class of appealing semiconductor materials for application in transparent electronics. In this work, a high performance bottom-gate n-type transparent thin-film transistors are reported, being the discussion primarily focused on the influence of the indium zinc oxide active layer thickness on the properties of the devices. For this purpose, transparent transistors with active layer thicknesses ranging from 15 nm to 60 nm were produced at room temperature using rf magnetron sputtering. Optical transmittance data in the visible range reveals average transmittance higher than 80%, including the glass substrate. The devices work in the enhancement mode and exhibit excellent saturation drain currents. On-off ratios above 107 are achieved, but this value tends to be lower for devices with thicker semiconductor films, as a result of the decrease in the resistance of the channel region with increasing thickness. Channel mobilities are also quite respectable, with some devices presenting values around 40 cm2/V s, even without any annealing or other post-deposition improvement processes. Concerning the evolution of threshold voltage with the thickness, this work shows that it increases from about 3 V in thicker films up to about 10 V in the thinnest ones. The interesting electrical properties obtained and the versatility arising from the fact that it is possible to modify them changing only the thickness of the semiconductor makes this new transparent transistors quite promising for future transparent ICs. © 2006 Elsevier B.V. All rights reserved.

In this work we present a study concerning the influence of some of the most important external factors on the electrical properties of transparent thin-film transistors (TFTs), using zinc oxide produced at room temperature as the semiconductor material. Electrical characterization performed sixteen months after the production of the devices showed a decrease in the on/off ratio from 8×105 to 1×105, mainly due to the increase of the off-current. We also observed a small increase in the saturation mobility, a decrease in the threshold voltage and an increase in the gate voltage swing (by factors of about 1.2, 0.9 and 1.6, respectively). Exposure to ambient light does not have a noticeable effect on the electrical properties, which is an important point as regards the application of these devices in active matrix displays. Some variation of the electrical properties was only detectable under intense white light radiation. In order to evaluate the temperature effect on the TFTs, they were also characterized at 90 °C. At this temperature we noticed that the off-current increased more than two times, and the other electrical properties had a small variation, returning to their initial values after cooling, meaning that the process is totally reversible. © 2005 Elsevier Ltd. All rights reserved.

This work aims to report results of the spatial and frequency optical detection limits of integrated arrays of 32 one-dimensional amorphous silicon thin film position sensitive detectors with nip or MIS structure, under continuous and pulsed laser operation conditions. The arrays occupy a total active area of 45 mm2 and have a plane image resolution better than 15 μm with a cut-off frequency of about 6.8 kHz. The non-linearity of the array components varies with the frequency, being about 1.6% for 200 Hz and about 4% for the cut-off frequency (6.8 kHz).

This paper presents the results achieved in optimized 1D position sensitive detectors (PSD) using a metal-insulator-semiconductor (MIS) structure and different length to width ratios, in order to determine the optimal geometrical factor for the desired 3D integration. The results show that the optimized MIS PSD produced, exhibited linearity errors as low as 0.8% and sensitivities of 32 mV/cm, for a 5 mW spot beam intensity at a wavelength of 532 nm. The sensors can achieve a longitudinal spatial resolution of 1.25 μm (estimated by modulation transfer function calculation), while the transverse resolution depends on the minimum width used for each sensor. The calculated Jones parameter of the sensors is higher than 1011 J, with a fall-off parameter of 0.012 cm-1, indicating a high signal to noise detection ratio. © 2006 Elsevier B.V. All rights reserved.

The Late Jurassic Lourinhã Formation contains a diverse dinosaur fauna comprising theropods, sauropods, stegosaurs, ankylosaurs and several genera of ornithopods.
The sedimentology in the area favours preservation of footprints, and footprints from most of the dinosaurs represented by skeletal remains are present in the area. During fieldwork in the summer of 2003 a new, large, tridactyl footprint was found at the beach of Vale Frades, approximately 6 km north of Lourinhã, Portugal. The footprint was found together with a stegosaur footprint on a clay bed exposed within the tidal zone. The footprints were preserved as sandstone casts standing on a pedestal of clay. This unusual type of preservation is the result of the footprints having first been emplaced in clay, and then filled with sand. During the present day erosion from the sea, the harder sandstone cast of the footprints protects the subjacent clay layers from erosion. Owing to the immediate danger of erosion of, the footprint was collected and is now on display at Museu da Lourinhã (ML 1000). The footprint is 70 cm long and 69 cm wide, the toes are short and broad, with indications of short blunt claws. The

divarication angle between the outer digits is close to 90 degrees. The dimensions and general

morphology of the footprint identifies it as deriving from an ornithopod dinosaur with an estimated hip height of 4.13 metres. Although very large ornithopods are known from the Cretaceous, the largest known Jurassic ornithopod is Camptosaurus from USA, and the largest known from Portugal is the camptosaurid Draconyx loureiroi. Neither of these reached the body size suggested by the new footprint. So far the footprint described herein is s the only evidence for a Jurassic ornithopod of that size.

n/a

The final thermally stimulated discharge current (FTSDC) technique can be used to analyze charge trapping and transport in insulating materials. The experimental conditions can be selected so that the FTSDC is mainly determined by the space charge detrapping. Measurements of the FTSDC in a wide temperature range including the local (secondary) beta relaxation and the non-local (primary) cc relaxation, for different polymers, demonstrate the existence of an apparent peak. The shift of peak temperature T-m with respect to the charging temperature T-p is analyzed. The interval T-m - T-p decreases from about 25 K to zero, as T-p approaches the glass transition T-g. T-m - T-p is lower for materials of lower conductivity. The peak width at the half maximum intensity decreases as Tp increases and the thermal apparent activation energy increases. The variations are not monotonous revealing the temperature range where the molecular motion is stronger and consequently the charge trapping and detrapping processes are affected by the strong thermal motion.

In this work we study the optical and electrical behavior of ZnO:Ga, ITO and IZO films deposited on glass after sustaining different hydrogen plasma conditions and exposure times. This work was complemented by analyzing the surface morphology of the set of films, which allow us to determine the role of hydrogen plasma on the film's properties such as Hall mobility, free carrier concentration, sheet resistance, optical transmittance, figure of merit and state of the surface. Apart from that, the performances of solar cells using an intrinsic layer constituted by nanocrystalline silicon will be also presented. The data show that the electrical properties of solar cells were improved by using ZnO:Ga as front contact, allowing a high current density collection and single pin solar cells with efficiencies exceeding 11%. © 2005 Materials Research Society.

In this work, metal induced crystallization using nickel was employed to obtain polycrystalline silicon by crystallization of amorphous films for thin film transistor applications. The devices were produced through only one lithographic process with a bottom gate configuration using a new gate dielectric consisting of a multi-layer of aluminum oxide/titanium oxide produced by atomic layer deposition. The best results were obtained for TFTs with the active layer of poly-Si crystallized for 20 h at 500 °C using a nickel layer of 0.5 nm where the effective mobility is 45.5 cm2 V-1 s-1. The threshold voltage, the on/off current ratio and the sub-threshold voltage are, respectively, 11.9 V, 5.55×104 and 2.49 V/dec. © 2005 Elsevier B.V. All rights reserved.

The aim of this work is to present data concerning the optimization of performances of a large area amorphous silicon p-i-n solar cell (30×40 cm2) deposited by plasma enhanced chemical vapour deposition (PECVD) at 27.12 MHz. In this work the solar cell was split into small areas of 0.126 cm2, aiming to study the device performance uniformity, where emphasis was put on the role of the n-layer thickness. The solar cells were studied through the spectral response behaviour in the 400-750 nm range as well as by the behaviour of the AC impedance. Solar cells with fill factor of 0.58, open circuit voltage of 0.83 V, short circuit current density of 17.14 mA/cm2 and an efficiency of 8% were obtained at growth rates higher than 0.3 nm/s. © 2004 Elsevier B.V. All rights reserved.