The experimental research carried out to study the punching behavior of high strength concrete (HSC) flat slabs is reported in the present work. Three flat slab specimens were cast using HSC and another one with normal strength concrete (NSC), to be used as a reference slab. The HSC mix presented a compressive strength of about 130MPa, with a basalt coarse aggregate. The tested specimens were square with 1650mm side and 125mm thickness. The longitudinal reinforcement ratio varied between 0.94{%} and 1.48{%}. The experimental results show that the use of HSC led to a significant load capacity increase when compared with the reference model made with NSC. Furthermore, the experimental results also indicated that as the longitudinal reinforcement ratio increased, the punching capacity also increased. The results obtained in this set of experimental tests and others collected from the literature were compared with the code provisions by EC2, MC2010 and ACI 318-11.

The integration of high temperature superconductors (HTS) in electrical machines potentially allows reduction in devices dimensions or performance improvement for the same active volume, when compared with their conventional ones. The use of polycrystalline HTS samples allows big bulk samples. An axial disc motor with HTS material or conventional aluminium in the rotor and conventional armature has been designed and developed. This paper describes simulations and laboratory experiments performed at liquid nitrogen temperature (77 K) in order to analyze the motor's behaviour and its electromechanical characteristics and to define an electric equivalent circuit that allows describing its operation. In order to evaluate the superconducting quality of the bulks and flux pinning phenomena, Hall probe mapping system was performed in order to define the field profiles at 77 K for different polar configurations. The analysis of the obtained results allows confirm the flux pinning phenomena, being the entire rotor magnetized and conclude that the motor with the HTS rotor behaves as a conventional hysteresis motor even though with a different nature, while the motor with aluminium rotor behaves as a conventional induction motor. In asynchronous regime, the HTS motor exhibits a constant torque, higher than the conventional aluminium one. For both cases, the developed torque is proportional to the poles pairs.

n/a

Nuclear Inst. and Methods in Physics Research, B, 365 (2015) 457-461. doi:10.1016/j.nimb.2015.07.006

Physica Scripta, 90(2015) 054009. doi:10.1088/0031-8949/90/5/054009

The solution of the Conic Quadratic Eigenvalue Complementarity Problem (CQEiCP) is first investigated without assuming symmetry on the matrices defining the problem. A new sufficient condition for existence of solutions of CQEiCP is presented, extending to arbitrary pointed, closed and convex cones a condition known to hold when the cone is the nonnegative orthant. We also address the symmetric CQEiCP where all its defining matrices are symmetric. We show that, assuming that two of its defining matrices are positive definite, this symmetric CQEiCP reduces to the computation of a stationary point of an appropriate merit function on a convex set. Furthermore, we discuss the use of the so called Spectral Projected Gradient (SPG) algorithm for solving CQEiCP when the cone of interest is the second-order cone (SOCQEiCP). A new algorithm is designed for the computation of the projections required by the SPG method to deal with SOCQEiCP. Numerical results are included to illustrate the efficiency of the SPG method and the new projection technique in practice.

X-ray intensity ratios, such as the Kα2/Kα1 ratio, are parameters with a large application in atomic physics and related scientific and technological areas. D.

In this work we calculate photoionization and X-ray production cross-sections (XPCS) of M-shell vacancies in Hg at incident photon energy of 5.96 keV (low.