n/a

n/a

Experimental relative transition probabilities for the 16 more pro-eminent lines arising from the 6p configurations of Au II were determined from the emission-line intensities in a laser-produced plasma. The experiment was carried out using a Cu-Au alloy with 10% Au content in order to obtain an optically thin plasma. Transition probabilities were placed on an absolute scale by using theoretical lifetimes calculated in this work, line-strength sum rules and Boltzmann plot. A comparison has been conducted between present experimental results, the theoretical data available and new calculations with the multi-configuration Dirac-Fock method reported in this work, as well as a study of the plasma conditions.

Experimental relative transition probabilities for the 16 more pro-eminent lines arising from the 6p configurations of Au II were determined from the emission-line intensities in a laser-produced plasma. The experiment was carried out using a Cu-Au alloy with 10% Au content in order to obtain an optically thin plasma. Transition probabilities were placed on an absolute scale by using theoretical lifetimes calculated in this work, line-strength sum rules and Boltzmann plot. A comparison has been conducted between present experimental results, the theoretical data available and new calculations with the multi-configuration Dirac-Fock method reported in this work, as well as a study of the plasma conditions.

A homogeneous black coloured glass was obtained by melting the bottom ashes produced by a municipal solid waste incinerator at 1300°C for 2 h without any chemical additives. Based on thermal analysis data glass-ceramics were produced by heat treating the glass, doped with additional TiO2 as a nucleating agent, at temperatures between 870 and 1000°C. The crystalline phases precipitated during the heat treatments were identified by powder XRD and the microstructures were examined using SEM. After a heat treatment at 900°C for 2 h, the glass was converted into a fine grained glass-ceramic with uniform microstructure. The major crystalline phases precipitated in the glass-ceramics were augite (Ca(Mg,Fe)Si2O6), gehlenite (Ca2Al2SiO7) and clinopyroxene (Ca(Ti,Mg,Al)(Si,Al)2O6). Preliminary evaluation of the mechanical and chemical properties of the bottom ash glasses and glass-ceramics suggest that they have potential to compete with existing natural and commercial outdoor cladding materials.

n/a

n/a

Cork is a natural cellular and electrically insulating material which may have the capacity to store electric charges on or in its cell walls. Since natural cork has many voids, it is difficult to obtain uniform samples with the required dimensions. Therefore, a more uniform material, namely commercial cork agglomerate, usually used for floor and wall coverings, is employed in the present study. Since we know from our previous work that the electrical properties of cork are drastically affected by absorbed and adsorbed water, samples were protected by means of different polymer coatings (applied by spin-coating or soaking). Corona charging and isothermal charging and discharging currents were used to study the electrical trapping and detrapping capabilities of the samples. A comparison of the results leads to the conclusion that the most promising method for storing electric charges in this cellular material consists of drying and coating or soaking with a hydrophobic, electrically insulating polymer such as polytetraflouroethylene (Teflon (R)).

Cork is a natural cellular and electrically insulating material which may have the capacity to store electric charges on or in its cell walls. Since natural cork has many voids, it is difficult to obtain uniform samples with the required dimensions. Therefore, a more uniform material, namely commercial cork agglomerate, usually used for floor and wall coverings, is employed in the present study. Since we know from our previous work that the electrical properties of cork are drastically affected by absorbed and adsorbed water, samples were protected by means of different polymer coatings (applied by spin-coating or soaking). Corona charging and isothermal charging and discharging currents were used to study the electrical trapping and detrapping capabilities of the samples. A comparison of the results leads to the conclusion that the most promising method for storing electric charges in this cellular material consists of drying and coating or soaking with a hydrophobic, electrically insulating polymer such as polytetraflouroethylene (Teflon (R)). (c) 2007 Elsevier B.V. All rights reserved.

n/a

n/a

Although occurrences of marine reptiles have been previously reported from Angola, with the exception of two Turonian taxa, these reports were based largely on isolated teeth. Fieldwork in 2005 and 2006 yielded well-preserved remains of marine reptiles including plesiosaurs, turtles, and mosasaurs. The mosasaurs discussed here were recovered from two field areas: Turonian sediments at Iembe along the north coast and Maastrichtian sediments at Bentiaba on the south coast. The Turonian section near Iembe produced at least two new specimens of Angolasaurus bocagei and one fragmentary specimen of Tylosaurus iembeensis. One of the Angolasaurus specimens is represented by a well preserved, complete and articulated skull and partial postcrania, including portions of the forelimbs and pectoral girdle. The preservation of material from the Bentiaba locality is remarkable due to the grain support of the entombing sandstone, which preserves fine anatomical details with little apparent crushing, and in the number of articulated, semi-articulated, and associated skeletons. Identifications from the field and preliminary preparation show the Bentiaba mosasaur fauna is represented by at least five genera including Mosasaurus, Prognathodon, Globidens, Plioplatecarpus and Halisaurus. Collectively, these new specimens greatly expand our knowledge of the anatomy and systematics of Angolan mosasaurs.

n/a

n/a

n/a

We report the 98% assignment of the apo-form of an orange protein, containing a novel Mo-Cu cluster isolated from Desulfovibrio gigas. This protein presents a region where backbone amide protons exchange fast with bulk solvent becoming undetectable. These residues were assigned using C-13-detection experiments.

The isoconversional methods (Friedman (FR), Flynn-Wall-Ozawa (FWO) and Kissinger-Akahira-Sunose (KAS)) were applied for evaluating the dependencies of the activation energy (E) on the mass loss (Δm) corresponding to the non-isothermal decomposition of two Zn acetate-based gel precursors for ZnO thin films whose preparation differs by the drying temperature of the liquid sol-precursor (125°C for sample A, and 150°C for sample B). Although both investigated samples exhibit similar decomposition steps, strong differences between E vs. Δm curves as well as among the characteristic parameters of the decomposition steps, directly evaluated from TG, DTG and DTA curves, were put in evidence. © 2007 Springer Science+Business Media LLC.

n/a

n/a

n/a

n/a

n/a

This study describes the characterisation of whey protein hydrolysates obtained from tryptic hydrolysis to assess their application as ingredients with angiotensin-converting-enzyme (ACE) inhibitory action. The levels of a-lactalbumin (alpha-la) and P-lactoglobulin (beta-lg) remaining after hydrolysis were quantified. Peptides were separated by RP-HPLC, and Ala-Leu-Pro-Met-His-Ile-Arg (ALPMHIR), the most potent beta-lg-derived ACE-inhibitory peptide was monitored. A correlation curve was established for the production of this peptide as a function of hydrolysis time. Heat-induced gelation of hydrolysates was studied by small-deformation rheology. The gelation times and the strength of the final gels were highly dependent on the degree of hydrolysis. Smaller peptides liberated by hydrolysis contributed to the inability of whey protein hydrolysates to gel. (c) 2006 Elsevier Ltd. All rights reserved.

n/a