n/a

n/a

n/a

n/a

n/a

n/a

Database systems are a key component behind many of today’s computer systems. As a consequence, it is crucial that database systems provide correct and continuous service despite unpredictable circumstances, such as software bugs or attacks. This paper presents the design of Byzantium, a Byzantine fault-tolerant database replication middleware that provides snapshot isolation (SI) semantics. SI is very popular because it allows increased concurrency when compared to serializability, while providing similar behavior for typical workloads. Thus, Byzantium improves on existing proposals by allowing increased concurrency and not relying on any centralized component. Our middleware can be used with off-the-shelf database systems and it is built on top of an existing BFT library.

n/a

n/a

n/a

n/a

The characterization of the bottom ashes produced by two Portuguese municipal solid waste incinerators (MSWI) was performed with the aim of assessing the feasibility of using this waste as raw material in the production of glass that can be further processed as glass-ceramics for application in construction. Density and particle size distribution measurements were carried out for physical characterization. Chemical characterization revealed that SiO2, a network glass former oxide, was present in a relatively high content (52-58 wt%), indicating the suitability for this waste to be employed in the development of vitreous materials. CaO, Na2O and K2O, which act as fluxing agents, were present in various amounts (2-17 wt%) together with several other oxides normally present in ceramic and glass raw materials. Mineralogical characterization revealed that the main crystalline phases were quartz (SiO2) and calcite (CaCO3) and that minor amounts of different alkaline and alkaline-earth aluminosilicate phases were also present. Thermal characterization showed that the decomposition of the different compounds occurred up to 1100 °C and that total weight loss was <10 wt%. Heating both bottom ashes at 1400 °C for 2 h resulted in a melt with suitable viscosity to be poured into a mould, and homogeneous black-coloured glasses with a smooth shiny surface were obtained after cooling. The vitrified bottom ashes were totally amorphous as confirmed by X-ray diffraction. The results from the present experimental work indicate that the examined bottom ashes can be a potential material to melt and to obtain a glass that can be further processed as glass-ceramics to be applied in construction. © 2007 Elsevier Ltd. All rights reserved.

n/a

Nanotechnology is having a positive impact on nearly every industry, and in particular in healthcare, where it is extending the limits of molecular diagnostics to the nanoscale-nanodiagnostics. Here we describe an innovative optoelectronic platform for the colorimetric detection of nucleic acids based on oligonucleotide-derivatized gold nanoparticles. The device integrates an amorphous/nanocrystalline biosensor and a light emission source with a gold nanoprobe for specific DNA detection. This low cost, fast and simple optoelectronic platform permits detection of few picomole of nucleic acid without target or signal amplification making it suitable for application in population diagnostics and in point-of-care hand-held devices. © 2007 Elsevier B.V. All rights reserved.

n/a

n/a

This paper presents an analytical model for CMOS delay and power estimation in deep sub micrometer technologies. In this paper the EKV transistor model is considered as a way of granting the accuracy of results in the characterization of deep submicron CMOS circuits. The analytical model proposed is valid for a ramp input signal, and takes into account all the operation regions of the transistor as well the influence of the gate-to-drain capacitance. For estimating the power consumption, a simple numerical integration process is applied to the current wave. An application example considering the use of the model for the evaluation of the delay and power consumption associated to a CMOS inverter is considered. The validity of the results obtained with the proposed model for a 1.2V TSMCN65 CMOS inverter is checked against those obtained through Hspice simulation.

N, (N+Ga) and (N+Al) doped ZnO films were deposited on c-plane sapphire substrates by RF magnetron sputtering at room temperature. The samples were characterized by their structural, surface morphological, compositional and optical properties. The x-ray diffraction studies confirmed the co-doping of (N+Ga) and (N+Al) besides showing improvement in the crystallinity when compared with the single Ndoping. The surface of the films becomes rougher after co-doping. The x-ray photoelectron spectroscopy and Rutherford back-scattering analysis indicate that the co-doping changes the chemical states and varies the amount of nitrogen (N) in ZnO. The amount of 'N' has been greatly increased for (N+Ga) co-doping, indicating that it is the best co-doping pair for p-type ZnO. Additionally, co-doping has increased the average visible transmittance (40-650nm) and the optical band gap is shifted towards shorter wavelength. In the case of (N+Al) co-doping, the band gap becomes wider than that of undoped ZnO. © IOP Publishing Ltd.

n/a

In this work we studied indium zinc oxide (IZO) thin films deposited by r.f. magnetron sputtering at room temperature. The films were annealed at high temperature (1100 K) in vacuum, and the oxygen exodiffusion was monitored in-situ. The results showed three main peaks, one at approximately 600 K, other at approximately 850 K and the last one at 940 K, which are probably from oxygen bonded in the film surface and in the bulk, respectively. The initial amorphous structure becomes microcrystalline, according to the X-ray diffraction. The electrical conductivity of the films decreases (about 3 orders of magnitude), after the annealing treatment. This behavior could be explained by the crystallization of the structure, which affects the transport mechanism. Apart from the changes in the material structure, a small variation was observed on the absorption coefficient. © 2007 Elsevier B.V. All rights reserved.

n/a

n/a

n/a

n/a