n/a

n/a

The position of a 40 μm wide by 400 μm long cantilever in a microscope was detected by a 32 lines array of 1D amorphous silicon position sensitive detectors (PSD). The sensor was placed in the ocular used for the CCD camera of a microscope and the alignment, focusing and positioning of the cantilever was achieved using the X-Y-Z translation table of the microscope that has a micrometer resolution controller. In this work we present results concerning the micro positioning of a cantilever and its holding structure through the reflected light that is detected by 1D/3D psd and converted to an analog signal proportional to the movement. The signal given by the 32 sensor array was analyzed directly without any electronic readout system or data algorithm. The obtained results show a linear behavior of the photovoltage relating X and Y movement, a non-linearity less than 2% and spatial resolution of 600 μV/μm. © 2006 Elsevier B.V. All rights reserved.

n/a

We establish a Fredholm criterion for an arbitrary operator in the Banach algebra of singular integral operators
with piecewise continuous coefficients on Nakano spaces (generalized Lebesgue spaces with variable exponent) with Khvedelidze weights over Carleson curves with logarithmic whirl points.

This work deals with the study of the role of the film thickness and composition on the color selectivity of the collecting spectrum of glass/ZnO:Ga/p-a-Si1-xCx:H/ a-Si1-x C x:H /a-Si:H/n-a-Si:H/Al photoelectronic detectors produced in a single chamber plasma enhanced chemical vapor deposition (PECVD) system. The cross contaminations were minimized by a rotate-cover substrate holder system. The devices can detect the blue illumination at small reverse bias and detect red illumination at large reverse bias. The role of the process parameters, especially the thickness of the p-type and intrinsic a-Si1-x C x:H, and the intrinsic a-Si:H layers on the device performances were studied in detail aiming to achieve a better detectivity. © 2005 Materials Research Society.

A series of hydrogenated amorphous silicon carbide (a-SiC:H) films was prepared by plasma enhanced chemical vapor deposition (PECVD) technology. The microstructure and photoelectronic properties of the film are investigated by absorption spectra (in the ultraviolet to near-infrared range) and Fourier transform infrared (FTIR) spectra. The results show that good band gap controllability (1.83-3.64 eV) was achieved by adjusting the plasma parameters. In the energy range around 2.1 eV, the a-Si1-xCx:H films exhibit good photosensitivity, opening the possibility to use this wide band gap material for device application, especially when blue color detectors are concerned. A multilayer device with a stack of glass/TCO(ZnO:Ga)/P(a-SiC:H)/I(a- SiC:H)/N(a-Si:H)/I(a-Si:H)/P(a-Si:H)/Al has been prepared. The devices can detect blue and red colors under different bias voltages. The optimization of the device, especially the film thickness and the band gap offset used to achieve better detectivity, is also done in this work. © 2005 Elsevier B.V. All rights reserved.