Os sistemas de reforço por colagem exterior têm sido alvo de várias abordagens, não só do ponto de vista do tipo de material a utilizar, como também sob o ponto de vista da técnica mais eficiente a seguir. As fibras reforçadas com polímeros (FRP) têm sido, no último par de décadas, alvo de investigação exaustiva, tendo-se verificado que esses sistemas nutrem de ductilidade algo reduzida devido ao descolamento prematuro do material de reforço da superfície de betão. Por conseguinte, o aço inox devidos às suas boas características anticorrosivas e ductilidade apresenta-se como uma alternativa viável aos compósitos de FRP. Assim, com vista a melhorar a ductilidade dos elementos estruturais reforçados, em vez de se recorrer a técnicas de reforço não tradicionais (e.g., Externally Bonded Reinforcement (EBR) ou Near Surface Mounted (NSM)) que estão sempre associadas a roturas prematuras por colagem do elemento de reforço quando a extensão nele instalada está muito aquém do seu valor de rotura, dever-se-á seguir outras técnicas de reforço por colagem. Com vista a interpretar e perceber o desempenho da ligação aço-inox, desenvolveu-se uma campanha experimental em que os ensaios visam em testar e comparar a técnica EBR com uma técnica inovadora e desenvolvida pelos autores (CREatE – Continuous Reinforcement Embedded at Ends) através da realização de ensaios de arrancamento de ligações aço inox/betão. Estes ensaios consistem em aplicar uma força à barra de aço inox segundo uma direção que permite induzir uma rotura da ligação consistente com o Modo II de fratura. A técnica de correlação de imagem digital (DIC) foi utilizada na monitorização de todos estes ensaios tendo-se desenvolvido ainda diferentes modelos, analíticos e numéricos com recurso a um programa de cálculo automático não linear, que permitiram simular os processos de descolamento da ligação aço inox/betão segundo as técnicas EBR e CREatE.

This 1st Report of the project CrowdWork21 presents a summary of the information collected about workers in digital platforms by country (German, Hungary, Portugal and Spain). Each national report describes first the scientific debates about workers of digital platforms. After, the reports present the information collected about the national public debates and identifies the angles normally covered by the media in relation to the organisation of digital workers. Lastly, the reports present initial conclusions about the information collected in each country.

n/a

In this paper we characterize the monoids of endomorphisms of the semigroups PO_n and POI_n of all order-preserving partial transformations and of all order-preserving partial permutations, respectively, of a finite n-chain.

This chapter provides an overview of the alpha paleobiodiversity of Angola based on the available fossil record that is limited to the sedimentary rocks, ranging in age from Precambrian to the present. The geological period with the highest paleobiodiversity in the Angolan fossil record is the Cretaceous, with more than 80{%} of the total known fossil taxa, especially marine molluscs, including ammonites as a majority among them. The vertebrates represent about 15{%} of the known fauna and about one tenth of them are species firstly described based on specimens from Angola.

Accumulative Roll Bonding (ARB) was used to fabricate Graphene Oxide-reinforced Al-matrix composites.
Graphene Oxide reinforcement was suspended in a stabilized aqueous solution and applied, prior to each ARB
cycle, through airgun spraying. Different concentrations (graphene oxide/milipore water) were used and for
each concentration, samples produced have undergone up to 5 rolling cycles.
Optical and electron scanning microscopies were used for microstructural characterization which revealed a
non-homogenous deformation of the layers across the composite's thickness.
Although the presence of graphene-oxide promoted an increase in the microhardness, higher values were
obtained with its lowest concentration for similar samples. The number of ARB cycles and the direction of the
tested sections also influenced the microhardness results since the 5-cycle samples and the rolling direction
sections for all the samples achieved higher hardness results. Graphene Oxide revealed to be a major contributor
to the increase of stiffness during bending of the tested samples.

Este capítulo apresenta uma visão geral da paleobiodiversidade alfa de Angola com base no registo fóssil disponível, o qual se limita às rochas sedimentares, a sua idade variando entre o Pré‑Câmbrico e o pre‑
sente. O período geológico com a maior paleobiodiversidade no registo fóssil angolano é o Cretácico, com mais de 80% do total dos táxones fósseis conhecidos, especialmente moluscos marinhos, sendo estes na sua maioria
amonites. Os vertebrados representam cerca de 15% da fauna conhecida e cerca de um décimo destes são espécies descritas pela primeira vez com base em espécimes de Angola.

A zig-zag (or fence) order is a special partial order on a (finite) set. In this paper, we consider the semigroup $TF_{n}$ of all
order-preserving transformations on an $n$-element zig-zag ordered set. We determine the rank of $TF_{n}$ and provide a minimal generating set for $TF_{n}$. Moreover, a formula for the number of idempotents in $TF_{n}$ is given.

The normality of the log-return of stock prices is often assumed by the market players in order to use some useful results, as for instance, the Black-Scholes formula for pricing European options. However, several studies regarding different indexes have shown that the normality assumption of the returns usually fails.
In this paper we analyse the normality assumption for intra-day and inter-day log-returns, comparing opening prices and/or closing prices for a large number of companies quoted in the Nasdaq Composite index. We use the Pearson's Chi-Square, Kolmogorov-Smirnov, Anderson-Darling, Shapiro-Wilks and Jarque-Bera goodness-of-fit tests to study the normality assumption.
We find that the failure rate in the normality assumption for the log-return of stock prices is not the same for intra-day and inter-day prices, is somewhat test dependent and strongly dependent on some extreme price observations.
To the best of our knowledge, this is the first study on the normality assumption for the log-return of stock prices dealing simultaneously with a large number of companies and normality tests, and at the same time considering various scenarios of intra-day, inter-day prices and data trimming.

This paper presents a study of the behaviour and load capacity of steel-fibre-reinforced concrete (SFRC) flat slabs under monotonically increased concentrated vertical loads. The SFRC was used only in the local region of the slab–column connection, as the rest of the slab was cast using normal concrete without fibres. The six experimental test specimens had a thickness of 150 mm with different longitudinal reinforcement ratios, using a non-uniform distribution over the slab width. The concretes used were made with different Dramix 4D 65/60 BG steel fibre contents (0, 0·5, 0·75 and 1·0% volume content). The slab tests were complemented by flexural tests on notched beams. This made it possible to determine the tension behaviour of the different concretes used, through a linear post-cracking behaviour and inverse analysis. The inverse analysis made it possible to define the stress–crack opening relationship that characterises the tension behaviour of SFRC and to relate it to the observed behaviour and load capacity of the tested slabs. The tests results show that the tensile behaviour of the SFRC plays an important role in the behavioural and load capacity of the slabs and that it can be considered relevant to physically based models.