Rodrigo Martins

Indium molybdenum oxide thin films radio-frequency sputtered at room temperature on glass were studied as a function of oxygen volume percentage. The as-deposited films were post-annealed in the temperature range of 300-500 °C in oxidizing (open air) and reducing (N2:H2 gas) atmospheres for 1 h. The as-deposited amorphous films become crystalline on post-annealing irrespective of the annealing conditions. In most cases, the (2 2 2) diffraction line is emerged as the high intensive peak. The films annealed at ≥400 °C in N2:H2 show a carrier concentration >1020 cm-3. The better electrical properties are obtained for the films post-annealed at 300 °C. The optical transmittance of the as-deposited films varies between 10% and 85% depending on the deposition and annealing conditions. Atomic force microscope analysis reveal that the films annealed at 300 °C are composed of closely packed crystallites (size of which varies between 5 nm and 150 nm) whose size varies noticeably when the annealing temperature is raised to 400 °C. On the other hand, the surface of the films annealed at 500 °C becomes rougher, with the RMS roughness varying between 2.00 nm and 16.97 nm. The surface of the films deposited in the presence of oxygen shows metal like features when annealed at ≥400 °C in N2:H2 that is attributed to the segregation of indium. Further, the segregation of In is substantiated from the scanning electron microscope analysis of these samples. © 2008 Elsevier B.V. All rights reserved.

N-doped ZnO films were deposited by RF magnetron sputtering in N2/Ar gas mixture and were post-annealed at different temperatures (Ta) ranging from 400 to 800 °C in O2 gas at atmospheric pressure. The as-deposited and post-annealed films were characterized by their structural (XRD), compositional (SIMS, XPS), optical (UV-vis-NIR spectrometry), electrical (Hall measurements), and optoelectronic properties (PL spectra). The XRD results authenticate the improvement of crystallinity following post-annealing. The weak intensity of the (0 0 2) reflection obtained for the as-deposited N-doped ZnO films was increased with the increasing Ta to become the preferred orientation at higher Ta (800 °C). The amount of N-concentration and the chemical states of N element in ZnO films were changed with the Ta, especially above 400 °C. The average visible transmittance (400-800 nm) of the as-deposited films (26%) was increased with the increasing Ta to reach a maximum of 75% at 600 °C but then decreased. In the PL spectra, A0X emission at 3.321 eV was observed for Ta = 400 °C besides the main D0X emission. The intensity of the A0X emission was decreased with the increasing Ta whereas D0X emission became sharper and more optical emission centers were observed when Ta is increased above 400 °C. © 2008 Elsevier B.V. All rights reserved.

Thin films of molybdenum doped indium oxide (IMO) were deposited on glass at room temperature using an in-built three-source RF magnetron sputtering. The films were studied as a function of oxygen volume percentage (O2 vol. %; ranging from 0.0 to 17.5%) in the sputtering chamber. The as-deposited amorphous films were crystallized on post-annealing. The as-deposited films are low conducting and Hall coefficients were undetectable; whereas post-annealed films possess fairly high conductivity. The lowest transmittance (11.96% at 600 nm) observed from the films deposited without oxygen increased to a maximum of 88.01% (3.5 O2 vol. %); whereas this transmittance was decreased with the increasing O2 vol. % to as low as 81.04% (15.6 O2 vol. %); a maximum of 89.80% was obtained from the films annealed at 500 °C in open air (3.5 O2 vol. %). The optical band gap of 3.80 eV obtained from the films deposited without oxygen increased with increasing O2 vol. % to as high as 3.91 eV (17.5 O2 vol. %). A maximum of 3.92 eV was obtained from the films annealed at 300 °C in N2:H2 gas atmosphere (17.5 O2 vol. %). © 2008 Elsevier Ltd. All rights reserved.

This work presents a study performed on several Au contacts deposited by evaporation on oxide free and oxidised (5-20Å of oxide) a-Si:H surfaces. The characterisation of the films was performed on as deposited, aged and annealed at 150°C structures. SIMS and RBS measurements show that the Au diffuses very easily on oxide free a-Si:H surfaces, even at room temperature, resulting in the formation of an oxide at the device surface that acquires a blue colour instead of the gold colour of the contacts. This was also visible in the SEM pictures of the cross section of the structures produced and on the changes of the surface morphology observed by AFM measurements. On the other hand, when the Au is deposited on oxidised a-Si:H surfaces, the results show that the oxide prevents the Au from diffusing and the nature of the contact is preserved. That is, better rectifying and stability performances are obtained in MIS like structures than in Schottky structures.

This work presents a study on the effect of an interfacial silicon oxide layer placed between Au and a-Si:H MIS (metal-insulator-semiconductor) photodiodes in their performances, by stopping the Au diffusion towards the a-Si:H. The results show that the Au diffuses very easily to the oxide free a-Si:H surface, even at room temperature, degrading the photodiode performance. On the other hand, the MIS photodiodes with the interfacial oxide show an improvement of their characteristics after annealing, function of its thickness, and degree of film's compactness. This effect is associated with the presence of oxide of thicknesses ≥5 Å at the Au/a-Si:H interface that prevents the Au diffusion and improves the photodiode characteristics, which does not happen when the interfacial oxide is absent. © 2004 Elsevier B.V. All rights reserved.

In this study, amorphous indium-tungsten oxide (IWO) semiconductor thin films were prepared by an eco-friendly spin-coating process using ethanol and water as solvents. The electrical properties of IWO thin-film transistors (TFTs), together with the structural and morphological characteristics of IWO thin films, were systematically investigated as functions of tungsten concentration and annealing temperature. The optimized IWO channel layer was then integrated on an aqueous aluminum oxide (AlOx) gate dielectric. It is observed that the solution-processed IWO/AlOx TFT presents high stability and improved characteristics, such as an on/off current ratio of 5 × 107, a field-effect mobility of 15.3 cm2 V-1 s-1, a small subthreshold slope of 68 mV dec-1, and a threshold voltage shift of 0.15 V under bias stress for 2 h. The IWO/AlOx TFT could be operated at a low voltage of 2 V, which was 15 times lower than that of conventional SiO2-based devices. The solution-processed IWO thin films synthesized in a green route would be promising candidates for large-area and high-performance low-cost devices. © The Royal Society of Chemistry 2016.