Pedro Pereira

The complex data exchange between architectural design and building energy simulation constitutes the main challenge in the use of energy performance analyses in the early design stage. The enhancement of BIM model data with additional specific energy-related information and the subsequent mapping to the input of an energy analysis or simulation tool is yet an open issue. This paper examines three approaches for the data transfer from 3D CAD applications to building performance simulations using BIM as central data repository and points out their current and envisaged use in practice. The first approach addresses design scenarios. It focuses on the supporting tools needed to achieve interoperability given a 74 wide-spread commercial BIM model (Autodesk Revit) and a dedicated pre-processing tool (DesignBuilder) for EnergyPlus. The second approach is similar but addresses retrofitting scenarios. In both workflows gbXML is used as the transformation format. In the third approach a standard BIM model, IFC is used as basis for the transfer process for any relevant lifecycle phase.

This Chapter presents the optimal design of radio-frequency integrated spiral inductors. The basic idea is to generate an analytical model to characterize integrated inductors based on the double {\ensuremathπ}-model, and offer to the designer an approach to determine the inductor layout parameters. Particle Swarm Optimization technique is used to generate optimal values of parameters of the developed models. Viability of the proposed models is highlighted via comparison with ASITIC simulation results.

This paper presents the design of a test rig for an all HTS linear synchronous motor. Although this motor showed to have several unattractive characteristics, its design raised a number of problems which must be considered in future HTS machines design. HTS electromagnetic properties led to the development of new paradigms in electrical machines and power systems, as e. g. in some cases iron removal and consequent assembly of lighter devices. This is due to superconductor's ability to carry high currents with minimum losses and consequent generation in the surrounding air of flux densities much higher than the allowed by ferromagnetic saturation. However, severe restrictions in HTS power devices design that goes further beyond cryogenic considerations must be accounted in. This is usually the case when BSCCO tapes are used as conductors. Its bending limitations and the presence of flux components perpendicular to tape surface, due to the absence of iron, have to be considered for it may turn some possible applications not so attractive or even practically unfeasible. An all HTS linear synchronous motor built by BSCCO tapes as armature conductors and two trapped-flux YBCO bulks in the mover was constructed and thrust force measurements are starting to be performed. Although the device presents severe restrictions due to the exposed and other reasons, it allowed systematising its design. A pulsed-field magnetiser to generate opposite fluxes for both YBCO bulks is also detailed. Thrust force numerical predictions were already derived and presented.

Electrical Protective Devices are key elements in the electrical network. Their purpose is to perform fault detection in electric power systems, by analysing power system voltages and currents. In order to achieve a more centralized control, protective devices can be connected using Web Services through a Service-Oriented Architecture (SOA) approach. This work targets planning and specification of a mapping between Abstract Communication Service Interface (ACSI) Reporting and Device Profile for Web Services (DPWS) Eventing to achieve a better protective electrical devices control, obtaining an event based alert software system, replacing conventional polling-based systems.