Transparent electronics is today one of the most advanced topics for a wide range of device applications, where the key components are wide band gap semiconductors, where oxides of different origin play an important role, not only as passive components but also as active components similar to what we observe in conventional semiconductors. As passive components they include the use of these materials as dielectrics for a wide range of electronic devices and also as transparent electrical conductors for use in several optoelectronic applications, such as liquid crystal displays, organic light emitting diodes, solar cells, optical sensors etc. As active materials, they exploit the use of truly electronic semiconductors where the main emphasis is being put on transparent thin film transistors, light emitting diodes, lasers, ultraviolet sensors and integrated circuits among others. © 2011 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.

We report the architecture and the performances of a memory based on a single field-effect transistor built on paper able to write-erase and read. The device is composed of natural multilayer cellulose fibers that simultaneously act as structural support and gate dielectric; active and passive multicomponent amorphous oxides that work as the channel and gate electrode layers, respectively, complemented by the use of patterned metal layers as source/drain electrodes. The devices exhibit a large counterclockwise hysteresis associated with the memory effect, with a turn-on voltage shift between 1 and -14.5 V, on/off ratio and saturation mobilities of about 104 and 40 cm 2 V-1 s-1, respectively, and estimated charge retention times above 14 000 h. © 2008 American Institute of Physics.

In this paper, an MILP formulation is proposed for the design of a reverse logistics network based on a warehouse location–allocation model, which optimizes, simultaneously, the forward and reverse networks. A single product model with unlimited capacity is first defined. Subsequently, the model is extended to a multi-product capacitated recovery network model, where capacity limitations and a multi-product system can be considered. The proposed model is compared to published work in the field, where different model assumptions have been proposed. Two cases are described so as to gain a better insight into the model and allow a comparative analysis.

The fabrication of high field-effect mobility ZnO thin film transistor (ZnO-TFT) at room temperature by rf magnetron sputtering was discussed. The ZnO used was deposited onto borosilicate glass substrate with a thickness of 1 mm with 100 x 100 mm surface area, coated with a 200 nm sputtered ITO film. The hall mobilities of about 2 cm2 / V s and a carrier concentration of 3 x 1016cm-3 were measured for the films with lower resistivity. It was observed that the ZnO-TFT presented an average optical transmission of 80% in the visibility part of the spectrum.

n/a

The innovation in the employment behaviour is particularly clear in what concerns the sector composition of the employment changes: the persistent decrease of the industrial employment (even if within a framework of some recovery of the industrial product), a slight expansion in the employment on the tertiary sector, and an important growth of the employment in the construction and public works activities. We can identify then a considerable sector mutation concerning the industrial and the services sectors but also a growth of the atypical forms of employment. Portugal continues not being able to respond to the labour market needs (improvement in the education sector is critical to the catch-up process). The Portuguese cases studied point out to organisational changes supported by ICT, but not determined/induced by it. For most of the changes that were recently developed, ICT had an important role. We didn’t found explicit technological determinism in the relation between ICT and social exclusion.