This work aimed to study the effect of different pre-treatments applied to a potato peel residue, in a thermophilic Anaerobic Digestion (AD) process. All samples were subjected to a mechanical pre-treatment through milling to a particle size below 2 mm. The thermal pre-treatments applied consisted of autoclaving the residue at a gauge pressure of 1.2 bar, under a temperature of 122°C, and for 20, 35 and 55 minutes: assays E122.20, E122.35 and E122.55, respectively. The control assay was performed on a ground residue, which was not submitted to any thermal pre-treatment. All pre-treated residues were subjected to an AD process in a CSTR reactor at 49±1°C. The experimental data showed that the highest methane percentages were very similar (about 92% v/v) for all samples submitted to the thermal pre-treatments. For the control assay, the highest percentage of methane was 87.9% (v/v). The highest biogas yields were recorded in the trial E122.35 (646±50 cm3.g-1 CODremoved), against only 250±20 cm3.g-1 CODremoved for the control assay. The highest biogas yields for VSremoved were attained in the assays E122.55 and E122.35, with values of 646±48 cm3.g-1 VSremoved and 634±59 cm3.g-1 VSremoved, respectively. Globally, the yields registered for the assay E122.35 were similar to those determined in the assay E122.55. Due to the lower energy consumption during the pre-treatment performed in the assay E122.35, this was considered to be the most suitable pre-treatment for this type of residue.

The Late Triassic (ca. 237-201.5 million years ago) was a transitional interval in the evolution of terrestrial ecosystems, during which ‘modern’ clades such as archosaurs and mammals were radiating while ‘archaic’ groups such as temnospondyl amphibians and basal synapsids remained abundant. Little is known about the Triassic terrestrial (nonmarine) vertebrates of the Iberian Peninsula. The Algarve Basin of southern Portugal is an extensional rift basin formed during the breakup of Pangaea, which is filled with terrestrial, lacustrine, and marginal marine siliciclastics of the Grés de Silves Formation, interbedded with CAMP basalts that mark the end-Triassic extinction (radioisotopically dated to ~198-201.5 Ma). Since 2009, our field project in the Algarve has discovered numerous vertebrate specimens within the Grés de Silves, including a monodominant bonebed containing hundreds of specimens of metoposaurids, a peculiar group of temnospondyls that filled crocodile-like predatory niches in lacustrine and fluvial environments. These specimens appear to belong to a new species of Metoposaurus, similar to M. diagnosticus and M. krasiejowensis from central Europe but possessing several putative autapomorphies of the braincase and lower jaw. We also discovered a mandible of a phytosaur, the first specimen of these long-snouted, semi-aquatic archosauriforms from the Iberian Peninsula. These discoveries of characteristic Carnian Norian taxa indicate that the fossil-bearing portion of the Grés de Silves is Late Triassic in age, and provide further evidence that metoposaurids and phytosaurs commonly occurred together in low palaeolatitudes during this time.

We report here the addition of two rare mosasaur taxa to the Maastrichtian marine amniote fauna of Angola. The new specimens include a dentary fragment referable to the large carnivore Prognathodon saturator and an isolated tooth of the small durophage Carinodens belgicus. Both were recovered from Maastrichtian outcrops in southern Angola in 2011. Additionally, a complete posterior mandibular unit of a large mosasaur from the type Maastrichtian of The Netherlands, collected some time prior to 1879 and previously identified as ‘Mosasaurus giganteus’, is described and reassigned here to Prognathodon saturator; historical issues surrounding the taxonomic attribution of this specimen are clarified. The new material extends the known geographic distribution of Prognathodon saturator and Carinodens belgicus.

Magnetic shielding inductive fault currentlimiterswith high temperature superconducting cylinders have previously been described by a characteristic (or maximum)hysteresisloop, built from properties of their constitutive parts, which allowed predicting their behavior in electrical grids. These preliminary results were based on finite elements simulations, but posterior experiments suggested limitations in the models. In order to investigate the application of these previous models to real devices, two laboratory scale prototypes were built with different types of superconducting material in the secondary, either bulk cylinder, either tape. Although the behavior of both devices is still approximately defined by a maximumhysteresisloop, differences in the shielding current response, when compared with previous model, must be incorporated in future models.

Net Zero-Energy Buildings (NZEBs) have received increased attention in recent years as a result of constant concerns about energy supply constraints, decreasing energy resources, increasing energy costs and the rising impact of greenhouse gases on world climate. Promoting whole building strategies that employ passive measures together with energy efficient systems and technologies using renewable energy became a European political strategy following the publication of the Energy Performance of Buildings Directive recast in May 2010 by the European Parliament and Council. However designing successful NZEBs represents a challenge because the definitions are somewhat generic while assessment methods and monitoring approaches remain under development and the literature is relatively scarce about the best sets of solutions for different typologies and climates likely to deliver an actual and reliable performance in terms of energy balance (consumed vs generated) on a cost-effective basis. Additionally the lessons learned from existing NZEB examples are relatively scarce. The authors of this paper, who are participants in the IEA SHC Task 40-ECBCS Annex 52, "Towards Net Zero Energy Solar Buildings", are willing to share insights from on-going research work on some best practice leading NZEB residential buildings. Although there is no standard approach for designing a Net Zero-Energy Building (there are many different possible combinations of passive and efficient active measures, utility equipment and on-site energy generation technologies able to achieve the net-zero energy performance), a close examination of the chosen strategies and the relative performance indicators of the selected case studies reveal that it is possible to achieve zero-energy performance using well known strategies adjusted so as to balance climate drivendemand for space heating/cooling, lighting, ventilation and other energy uses with climate-driven supply from renewable energy resources.

Li2O-BaO-Al2O3-La2O 3-P2O5 glasses optically activated with rare earth ions with the 4f5, and 4f8 electronic configuration (Sm3+ and Tb3+, respectively) were analyzed by Raman spectroscopy, absorption, excitation photoluminescence, decay curves and temperature dependent photoluminescence. The spectroscopic characteristics of the as-prepared and heat treated samples at temperatures below and above T g were studied as well as their room temperature photometric properties under ultraviolet excitation. All the doped glasses exhibit typical signatures of the lanthanides in their trivalent charge state. For the samarium doped glass heat treated at 250 C (<Tg) the Sm2+ luminescence was also observed. The analysis of the luminescence efficiency was performed in the interval range of 14 K to room temperature, where the integrated intensity of the luminescence was found to decrease for the Sm 3+ and Tb3+ ions in the studied temperature range. Luminescence decay curves were found to be non-exponential for the 4G5/2 → 6H7/2 and 5D3 → 7F4 transitions of the Sm3+ and Tb3+ ions, respectively. The results strongly suggest the occurrence of energy transfer processes through cross relaxation phenomena, mediated by dipole-dipole interaction in all the studied samples. The decay of the 5D4 → 7F5 emission of the Tb3+ ions was found to be single exponential with a time constant of ∼3.1 ms. Based on the spectroscopic characteristics, models for recombination processes are proposed. The room temperature luminance photometric properties with ultraviolet excitation show that the samarium doped glasses have much lower luminance intensity (around 0.3 Cd/m2) when compared with the 6-7 Cd/m2 observed for the terbium doped ones. © 2013 Elsevier B.V. All rights reserved.

{Aluminophosphate glasses belonging to the Li2O-BaO-Al 2O3- La2O3-P2O 5 system doped with Tb3+ were prepared and investigated. Methods as Induced Coupled Plasma-Mass Spectrometry (ICP-MS), Induced Coupled Plasma-Atomic Emission Spectroscopy (ICP-AES) and X-ray diffraction (XRD) have been used to establish the elemental composition of these vitreous materials. The influence of the Tb3+ ions on the optical properties of the phosphate glasses has been investigated in relation with the structural characteristics of the vitreous matrix. The optical behavior has been studied by ultra-violet-visible (UV-Vis) spectroscopy, revealing electronic transitions specific for terbium ions. Fluorescence spectroscopy measurements have been performed by excitation in the UV and visible domains (377 nm and 488 nm) which resulted in the most significant fluorescence peaks in the Vis domain (540 and 547 nm). Structural information via vibration modes were provided by Fourier Transform Infrared (FTIR) absorption spectra in the 400-4000 cm-1 range. Absorption peaks specific for the vitreous phosphate matrix were put in evidence as P-O-P symmetrical and asymmetrical stretching vibration modes, P-O-P bend, PO2- symmetrical and asymmetrical stretching vibration modes