Molybdenum doped indium oxide (IMO) thin films rf sputtered at room temperature were studied as a function of oxygen volume percentage (O 2 vol. %) varied between 0 and 17.5. The as-deposited films were amorphous irrespective of O2 vol. %. The minimum transmittance (<10 %) of the films deposited without oxygen has been increased on introducing oxygen (3.5 O2 vol. %) to a maximum of 90 %. The optical band gap has been increased from 3.80 eV (without oxygen) to 3.92 eV (3.5 O 2 vol. %). The films were highly resistive and the hall coefficients were detectable only for the films deposited without oxygen. In order to increase the electrical conductivity, the films were annealed in the range 100-500° C in open-air and N2/H: gas for 1 hour. The annealed films become polycrystalline with enhanced electrical and optical properties. The effect of annealing conditions on these films will be presented and discussed in detail. © 2006 Materials Research Society.

n/a

n/a

n/a

n/a

n/a

n/a

n/a

The aim of this work is to optimize the metal/silicon ratio on nickel metal induced crystallization of silicon. For this purpose amorphous silicon layers with 80, 125 and 220 nm thick were used on the top of which 0.5 nm of Ni was deposited and annealed during the required time to full crystallize the a-Si. The data show that the 80 nm a-Si layer reaches a crystalline fraction of 95.7% (as detected by spectroscopic ellipsometry) after annealed for only 2 hours. No significant structural improvement is detected by ellipsometry neither by XRD when annealing the films for longer times. However, on 125 nm thick samples, after annealing for 2 hours the crystalline fraction is only 59.7%, reaching a similar value to the one with 80 nm only after 5 hours, with a crystalline fraction of 92.2%. Here again no significant improvements were achieved by using longer annealing times. Finally, the 220 nm thick a-Si sample is completely crystallized only after 10 hours annealing. These data clear suggest that the crystallization of thicker a-Si layers requires thicker Ni films to be effective for short annealing times. A direct dependence of the crystallization time on the metal/silicon ratio was observed and estimated. © 2005 Materials Research Society.

n/a

n/a

In this paper we present results of intrinsic/non-doped zinc oxide deposited at room temperature by radio frequency magnetron sputtering able to be used as a semiconductor material on electronic devices, like for example ozone gas sensors, ultra-violet detectors and thin film transistors. These films present a resistivity as high as 2.5×108 Ω cm with an optical transmittance of 90%. Concerning the structural properties, these films are polycrystalline presenting a uniform and very smooth surface. © 2005 Elsevier B.V. All rights reserved.

n/a

n/a

n/a

Zinc oxide is a well-known wide band gap semiconductor material (3.4 eV at room temperature, in the crystalline form), which has many applications, such as for transparent conductors, varistors, surface acoustic waves, gas sensors, piezoelectric transducers and UV detectors. More recently, it is attracting considerable attention for its possible application to thin film transistors. In this paper, we present some of the recent results already obtained as well as the ones that are being developed in our laboratory. The main advantage presented by these new thin film transistors is the combination of high channel mobility and transparency produced at room temperature which makes these thin film transistors a very promising low cost device for the next generation of invisible and flexible electronics. Moreover, the processing technology used to fabricate this device is relatively simple and it is compatible with inexpensive plastic/flexible substrate technology. © 2005 Elsevier B.V. All rights reserved.

In the present work we have calculated several relativistic transition probabilities for the F-like ions with 10 less-than-or-equals, slant Z less-than-or-equals, slant 49, in the framework of the Multi-Configuration Dirac–Fock method, for applications on laserphysics and astrophysics. The lines considered correspond to transitions between levels of 2p43s, 2p43p and 2p43d configurations. The spectral fine structure is taken into consideration and the results for individual lines are given.

In the present work we have calculated several relativistic transition probabilities for the F-like ions with 10 less-than-or-equals, slant Z less-than-or-equals, slant 49, in the framework of the Multi-Configuration Dirac–Fock method, for applications on laserphysics and astrophysics. The lines considered correspond to transitions between levels of 2p43s, 2p43p and 2p43d configurations. The spectral fine structure is taken into consideration and the results for individual lines are given.

n/a

n/a

n/a

n/a

This paper presents the role of the deposition pressure and the rf power density on the optimization of the electrical, optical and structural properties of large area (30×40 cm2) indium-tin oxide films produced by rf magnetron sputtering, with growth rates exceeding 30 nm/min. The films were produced at room temperature under reactive plasma, followed by a thermal annealing in air or formic gas. The best films' uniformity (≤±5%), compactness and surface smoothness (preferential growth orientation along (222)); and electro-optical properties (resistivity and mobility, respectively, of about 7×10-4 Ω cm and 19.6 cm2 V -1 s-1, with transmittance of about 92%) were achieved using a rf power density of 0.92 W cm-2 and a pressure of 8.5×10-2 Pa, followed by its annealing in air by about 2 h at 773 K. © 2005 Elsevier B.V. All rights reserved.

n/a

The aim of this paper is to present results concerning the role of the buffer layer on pin devices, deposited in a single chamber for plasma enhanced chemical vapor deposition, using high hydrogen dilution and pressures at 27.12 MHz. By doing so, we allow the incorporation of nanoparticles into the i-layer, during plasma process. The results show solar cells with 8.8% efficiency with a collection efficiency of 95% in the blue region of the spectra. Apart from that, the results from impedance spectroscopy, imaginary impedance vs. real impedance, show difference of a semicircle radius as function of sample temperatures, which could be explained by total device series resistance variation. © 2005 Elsevier B.V. All rights reserved.