Barros AA, Rita AN, Duarte AR, Pires RA, Sampaio-Marques B, Ludovico P, Lima E, Mano JF, Reis RL. {Bioresorbable ureteral stents from natural origin polymers}. Journal of Biomedical Materials Research - Part B Applied Biomaterials. 2015;103:608-17.
AbstractIn this work, stents were produced from natural origin polysaccharides. Alginate, gellan gum, and a blend of these with gelatin were used to produce hollow tube (stents) following a combination of templated gelation and critical point carbon dioxide drying. Morphological analysis of the surface of the stents was carried out by scanning electron microscopy. Indwelling time, encrustation, and stability of the stents in artificial urine solution was carried out up to 60 days of immersion. In vitro studies carried out with simulated urine demonstrated that the tubes present a high fluid uptake ability, about 1000{%}. Despite this, the materials are able to maintain their shape and do not present an extensive swelling behavior. The bioresorption profile was observed to be highly dependent on the composition of the stent and it can be tuned. Complete dissolution of the materials may occur between 14 and 60 days. Additionally, no encrustation was observed within the tested timeframe. The ability to resist bacterial adherence was evaluated with Gram-positive Staphylococcus aureus and two Gram-negatives Escherichia coli DH5 alpha and Klebsiella oxytoca. For K. oxytoca, no differences were observed in comparison with a commercial stent (Biosoft((R)) duo, Porges), although, for S. aureus all tested compositions had a higher inhibition of bacterial adhesion compared to the commercial stents. In case of E. coli, the addition of gelatin to the formulations reduced the bacterial adhesion in a highly significant manner compared to the commercial stents. The stents produced by the developed technology fulfill the requirements for ureteral stents and will contribute in the development of biocompatible and bioresorbable urinary stents.
Quraishi S, Martins M, Barros AA, Gurikov P, Raman SP, Smirnova I, Duarte AR, Reis RL. {Novel non-cytotoxic alginate–lignin hybrid aerogels as scaffolds for tissue engineering}. Journal of Supercritical Fluids. 2015;105:1-8.
AbstractThis paper presents a novel approach toward the production of hybrid alginate–lignin aerogels. The key idea of the approach is to employ pressurized carbon dioxide for gelation. Exposure of alginate and lignin aqueous alkali solution containing calcium carbonate to CO2at 4.5 MPa resulted in a hydrogel formation. Various lignin and CaCO3concentrations were studied. Stable hydrogels could be formed up to 2:1 (w/w) alginate-to-lignin ratio (1.5 wt{%} overall biopolymer concentration). Upon substitution of water with ethanol, gels were dried in supercritical CO2to produce aerogels. Aerogels with bulk density in the range 0.03–0.07 g/cm3, surface area up to 564 m2/g and pore volume up to 7.2 cm3/g were obtained. To introduce macroporosity, the CO2induced gelation was supplemented with rapid depressurization (foaming process). Macroporosity up to 31.3 ± 1.9{%} with interconnectivity up to 33.2 ± 8.3{%} could be achieved at depressurization rate of 3 MPa/min as assessed by micro-CT. Young's modulus of alginate–lignin aerogels was measured in both dry and wet states. Cell studies revealed that alginate–lignin aerogels are non-cytotoxic and feature good cell adhesion making them attractive candidates for a wide range of applications including tissue engineering and regenerative medicine.
Martins M, Barros AA, Quraishi S, Gurikov P, Raman SP, Smirnova I, Duarte AR, Reis RL. {Preparation of macroporous alginate-based aerogels for biomedical applications}. Journal of Supercritical Fluids. 2015.
AbstractAerogels are a special class of ultra-light porous materials with growing interest in biomedical applications due to their open pore structure and high surface area. However, they usually lack macroporosity, while mesoporosity is typically high. In this work, carbon dioxide induced gelation followed by expansion of the dissolved CO{\textless}inf{\textgreater}2{\textless}/inf{\textgreater} was performed to produce hybrid calcium-crosslinked alginate-starch hydrogels with dual meso- and macroporosity. The hydrogels were subjected to solvent exchange and supercritical drying to obtain aerogels. Significant increase in macroporosity from 2 to 25{%} was achieved by increasing expansion rate from 0.1 to 30 bar/min with retaining mesoporosity (BET surface and BJH pore volume in the range 183-544m{\textless}sup{\textgreater}2{\textless}/sup{\textgreater}/g and 2.0-6.8cm{\textless}sup{\textgreater}3{\textless}/sup{\textgreater}/g, respectively). In vitro bioactivity studies showed that the alginate-starch aerogels are bioactive, i.e. they form hydroxyapatite crystals when immersed in a simulated body fluid solution. Bioactivity is attributed to the presence of calcium in the matrix. The assessment of the biological performance showed that the aerogels do not present a cytotoxic effect and the cells are able to colonize and grow on their surface. Results presented in this work provide a good indication of the potential of the alginate-starch aerogels in biomedical applications, particularly for bone regeneration.
Barros AA, Aroso IM, Silva TH, Mano JF, Duarte AR, Reis RL. {Water and carbon dioxide: Green solvents for the extraction of collagen/gelatin from marine sponges}. ACS Sustainable Chemistry and Engineering. 2015;3:254-60.
AbstractMarine sponges are extremely rich in natural products and are considered a promising biological resource. The major objective of this work is to couple a green extraction process with a natural origin raw material to obtain sponge origin collagen/gelatin for biomedical applications. Marine sponge collagen has unique physicochemical properties, but its application is hindered by the lack of availability due to inefficient extraction methodologies. Traditional extraction methods are time consuming as they involve several operating steps and large amounts of solvents. In this work, we propose a new extraction methodology under mild operating conditions in which water is acidified with carbon dioxide (CO2) to promote the extraction of collagen/gelatin from different marine sponge species. An extraction yield of approximately 50{%} of collagen/gelatin was achieved. The results of Fourier transformed infrared spectroscopy (FTIR), circular dichroism (CD), and differential scanning calorimetry (DSC) spectra suggest a mixture of collagen/gelatin with high purity, and the analysis of the amino acid composition has shown similarities with collagen from other marine sources. Additionally, in vitro cytotoxicity studies did not demonstrate any toxicity effects for three of the extracts.