Sand pile and Bean models have already been applied to describe single grain HTS bulks. An extension to that approach was used to model multiseed bulks, needed for several practical applications as electric motors or flywheels with superconducting bearings. The use of genetic algorithms was then proposed to determine intra- and intergrain current densities, and application to two and three seeds samples using trapped flux experimental measurements was exemplified. However, this model assumed some simplifications, as equal properties in grain boundaries between neighboring grains. In this paper an extension to this methodology is proposed and evaluated by analyzing measurements performed in plans at different distances from surfaces of samples with three seeds. Discussion of its influence on a practical application is also explored.

n/a

Here we present for the first time a TiO2/Cu2O all-oxide heterojunction solar cell entirely produced by spray pyrolysis onto fluorine doped tin oxide (FTO) covered glass substrates, using silver as a back contact. A combinatorial approach was chosen to investigate the impact of the TiO2 window layer and the Cu2O light absorber thicknesses. We observe an open circuit voltage up to 350 mV and a short circuit current density which is strongly dependent of the Cu2O thickness, reaching a maximum of {\~{}}0.4 mA/cm2. Optical investigation reveals that a thickness of 300 nm spray pyrolysis deposited Cu2O is sufficient to absorb most photons with an energy above the symmetry allowed optical transition of 2.5 eV, indicating that the low current densities are caused by strong recombination in the absorber that consists of small Cu2O grains.

Journal of Physics B: Atomic, Molecular and Optical Physics, 48(2015) 185202. doi:10.1088/0953-4075/48/18/185202

n/a

ABSTRACT New elasmosaurid plesiosaur specimens are described from the Early Maastrichtian of Angola. Phylogenetic analyses reconstruct the Angolan taxon as an aristonectine elasmosaurid and the sister taxon of an unnamed form of similar age from New Zealand. Comparisons also indicate a close relationship with an unnamed form previously described from Patagonia. All of these specimens exhibit an ostensibly osteologically immature external morphology, but histological analysis of the Angolan material suggests an adult with paedomorphic traits. By extension, the similarity of the Angolan, New Zealand and Patagonian material indicates that these specimens represent a widespread paedomorphic yet unnamed taxon.

A new model based on Finite Fracture Mechanics (FFMs) has been proposed to predict the open-hole tensile strength of composite laminates [1]. Failure is predicted when bothstress-based and energy-based criteria are satisfied. This model is based on an analytical solution, and no empirical adjusting parameters are required, but only two material properties: the unnotched strength and the fracture toughness. In the present work, an extension of the proposed FFMs model to predict the notched response of composite laminates with notch geometries other than a circular opening [2] is presented and applied to the prediction of size effects on the tensile and compressive notched strength of composite laminates. The present model is also used to assess the notch sensitivity and brittleness of composite laminates by means of versatile design charts and by the identification of a dimensionless parameter designated as notch sensitivity factor. A further extension of the FFMs model is proposed, which takes into account the crack resistance curve of the laminate in the model's formulation, and it is used to predict the large damage capability of a non-crimp fabric thin-ply laminate [3].

ABSTRACT We report here a new elasmosaurid from the early Maastrichtian at Bentiaba, southern Angola. Phylogenetic analysis places the new taxon as the sister taxon to Styxosaurus snowii, and that clade as the sister of a clade composed of (Hydrotherosaurus alexandrae (Libonectes morgani + Elasmosaurus platyurus)). The new taxon has a reduced dorsal blade of the scapula, a feature unique amongst elasmosaurids, but convergent with cryptoclidid plesiosaurs, and indicates a longitudinal protraction-retraction limb cycle rowing style with simple pitch rotation at the glenohumeral articulation. Morphometric phylogenetic analysis of the coracoids of 40 eosauropterygian taxa suggests that there was a broad range of swimming styles within the clade.