Teresa Avilés

{Two new Ar-BIAN Cu(II) complexes (where Ar-BIAN = bis(aryl-imino)acenaphthene) of formulations {[}CuCl2(Mes-BIAN)] (1) (Mes = 2,4,6-Me3C6H2) and {[}CuCl2(Dipp-BIAN)] (2) (Dipp = 2,6-iPr(2)C(6)H(3)) were synthesised by direct reaction of CuCl2 suspended in dichloromethane with the respective ligands Mes-BIAN (L1) and Dipp-BIAN (L2), dissolved in dichloromethane, under an argon atmosphere. Attempts to obtain these compounds by solubilising CuCl2 in methanol and adding a dichloromethane solution of the corresponding ligand, under aerobic conditions, gave also compound 1, but, in the case of L2, the Cu(I) dimer {[}CuCl(Dipp-BIAN)](2) (3) was obtained instead of compound 2. The compounds were fully characterised by elemental analyses, MALDI-TOF mass spectrometry, FT-IR, H-1 NMR and EPR spectroscopic techniques. The solid-state molecular structures of compounds 1-3 were determined by single crystal X-ray diffraction, showing the expected chelation of the Ar-BIAN ligands and two chloride ligands completing the coordination sphere of the Cu(11) centre. In the case of the complex 1, an intermediate coordination geometry around the Cu(II) centre, between square planar and tetrahedral, was revealed, while the complex 2 showed an almost square planar geometry. The structural differences and evaluation of energetic changes were rationalised by DFT calculations. Analysis of the electrochemical behaviour of complexes 1-3 was performed by cyclic voltammetry and the experimental redox potentials for Cu(II)/Cu(I) pairs have been compared with theoretical values calculated by DFT in the gas phase and in dichloromethane and methanol solutions. The complex 1 exhibited good activity in the reverse atom transfer radical polymerisation (ATRP) of styrene.}

{The complex {[}Ph4P](2){[}Cu(bdt)(2)] (1(red)) was synthesized by the reaction of {[}Ph4P]2{[}S2MoS2CuCl] with H2bdt (bdt = benzene-1,2-dithiolate) in basic medium. 1(red) is highly susceptible toward dioxygen, affording the one electron oxidized diamagnetic compound {[}Ph4P]{[}Cu(bdt)(2)] (1(ox)). The interconversion between these two oxidation states can be switched by addition of O-2 or base (Et4NOH = tetraethylammonium hydroxide), as demonstrated by cyclic voltammetry and UV-visible and EPR spectroscopies. Thiomolybdates, in free or complex forms with copper ions, play an important role in the stability of 1(red) during its synthesis, since in its absence, 1(ox) is isolated. Both 1(red) and 1(ox) were structurally characterized by X-ray crystallography. EPR experiments showed that 1(red) is a Cu(II)-sulfur complex and revealed strong covalency on the copper-sulfur bonds. DFT calculations confirmed the spin density delocalization over the four sulfur atoms (76%) and copper (24%) atom, suggesting that 1(red) has a ``thiyl radical character{''}. Time dependent DFT calculations identified such ligand to ligand charge transfer transitions. Accordingly, 1(red) is better described by the two isoelectronic structures {[}Cu(I)(bdt(2), 4S(3-{*}))](2-) {[}Cu-II(bdt(2), 4S(4-))](2-). On thermodynamic grounds, oxidation of 1(red) (doublet state) leads to 1(ox) singlet state, {[}Cu-III(bd(t)2, 4S(4-))](1-).}

{Three new emissive 8-aminoquinoline derived probes (1)-(3) and one dinuclear Zn(II) complex (4) were synthesized and fully characterized. Their absorption spectra show maxima at 310-336 nm, and fluorescence emission between 456 and 498 nm. Compound (1) was characterized by single crystal X-ray diffraction. The effect upon Zn(II) and Cu(II) coordination to compounds (1)-(3) was studied by monitoring the changes in absorption and fluorescence spectra, and complemented by calculation of metal-ligand stability constants. The results indicate that compound (3) is the one that presents the most favorable geometry for coordinating two metal cations, fact that is confirmed by the synthesis of the dinuclear complex (4), with similar molecular geometry. (C) 2011 Elsevier B.V. All rights reserved.}

{Reaction of {[}Co(eta(5)-C5H5)(CO)(2)], 1, with 1,1'-bis(diphenylphosphino)ferrocene (dppf) yields the new trinuclear complex {[}Co(eta(5)-C5H5)(CO)](2)(mu-dppf), 2, which was structurally characterised by single crystal X-ray diffraction and showed two Co(eta(5)-C5H5)(CO) moieties covalently linked by a dppf bridge. Electrochemical studies in dichloromethane revealed that both Co(I) and Fe(II) in the precursors were oxidized to Co(II)/Co(III) and Fe(III), respectively. On the other hand, in 2 the two first oxidation waves were assigned to Co, the Fe(II) centre requiring a higher potential than in free dppf. DFT calculations showed that the HOMOs of 2 were localised in the Co fragments, owing to the destabilisation of the Co(eta(5)-C5H5)(CO) orbitals after binding dppf. (C) 2012 Elsevier B.V. All rights reserved.}

{Zinc alkyl cations supported by N,N-BIAN-type bidentate ligands were found to be highly active in the immortal ROP of epsilon-caprolactone to yield narrowly disperse and chain length-controlled poly(epsilon-caprolactone), whether in solution or bulk polymerization conditions.}

The deactivation reaction of the [CoCp(1,4-sigma-C(4)-[Ph](4))PPh(3)] catalyst for the cyclotrimerization of acetylenes has been kinetico-mechanistically studied under different temperature, pressure, and solvent conditions. The results indicate a dramatic change in mechanism from conventional to ionic liquid solvents due to the polarity of the medium.

New compounds of the general formulas [M(Ar-BIAN)(2)]BF(4) and [M(Ar-BIAN)(NCMe)(2)]BF(4), where M=Cu(1) or Ag(1) and Ar-BIAN = bis(aryl)acenaphthenequinonediimine, were synthesized by the direct reaction of [Cu(NCMe)(4)]BF(4) or [Ag(NCMe)(4)]BF(4) with the corresponding Ar-BIAN ligand in dried CH(2)Cl(2). The synthesized compounds are [M(o, d, p-Me(3)C(6)H(2)-BIAN)(2)]BF(4) where M = Cu(1) (1) and Ag(1) (2), [M(o,d-iPr(2)C(6)H(3)-BIAN)(NCMe)(2)]BF(4) where M = Cu(1) (3) and Ag(1) (4), and [Ag(o,d-iPr(2)C(6)H(3)-BIAN)(2)]BF(4) (5). The crystal structures of compounds 1-3 and 5 were solved by singlecrystal X-ray diffraction. In all cases copper(I) or silver(I) are in a distorted tetrahedron that is constructed from the four nitrogen atoms of the two a-diimine ligands or, in 3, from one a-diimine ligand and two acetonitrile molecules. All compounds were characterized by elemental analyses, matrix-assisted laser desorption ionization time-of-flight mass spectrometry, and IR, UV-vis, and (1)H NMR spectroscopy. The analysis of the molecular geometry and the energetic changes for the formation reactions of the complexes, in a CH(2)Cl(2) solution, were evaluated by density functional theory calculations and compared with the experimental results.

A novel flexible tripodal ligand derived from 3-methylindole, ("InTREN" L), and its mononuclear Zn(II), Cu(II), Ni(II), Hg(II) and Pd(II) complexes are described. All compounds gave analytically pure solid samples. Characterisation of the compounds was accomplished by (1)H NMR, IR and absorption spectroscopies, matrix-assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOF-MS) and elemental analysis and their geometry optimized using density functional theory (DFT).Time-dependent-density functional theory (TD-DFT) calculations have been used to assign the lowest energy absorption bands of the free ligand and the Zn(II) complex. The system is a very good candidate for in situ recognition/coordination effects by MALDI-TOF-MS spectrometry and absorption spectroscopy. The presence of three indole groups in InTREN opens up the possibility to synthesize new three-dimensional self-assembly supramolecular structures. (C) 2008 Elsevier B.V. All rights reserved.

The coordination properties of the beta-keto phosphine ligands R(2)PCH(2)C(O)Ph (HL(1), R = i-Pr; HL(2), R = Ph), of the new acetamide-derived phosphine ligand (i-Pr)(2)PNHC(O) Me (HL(3)) and of Ph(2)PNHC(O) Me (HL(4)) have been examined towards Ni(II) complexes. Comparisons are made between systems in which the PCH(2) function of the ketophosphine has been replaced with an isoelectronic PNH group in amide-derived ligands, or the PCH functionality of phosphinoenolates with a PN group in phosphinoiminolate complexes. Furthermore, ligands HL(2) and HL(4) reacted with [(eta(5)-C(5)H(5))CoI(2)(CO)] to afford the phosphine mono-adducts [(eta(5)-C(5)H(5))CoI(2){Ph(2)PCH(2)C(O)Ph}] (1) and [(eta(5)-C(5)H(5))CoI(2){Ph(2)PNHC(O)Me}] (3), respectively, which upon reaction with excess NEt(3) yielded the phosphinoenolate complex [(eta(5)-C(5)H(5))CoI{Ph(2)PCH (center dot center dot center dot) under barC((center dot center dot center dot) under barO)Ph}] (2) and the phosphinoiminolate complex [(eta(5)-C(5)H(5))CoI{Ph(2)PN (center dot center dot center dot) under barC((center dot center dot center dot) under barO)Me}] (4), respectively. The complexes cis-[Ni{(i-Pr)(2)PN (center dot center dot center dot) under barC((center dot center dot center dot) under barO)Me}(2)] (6) and cis-[Ni{Ph(2)PN (center dot center dot center dot) under barC((center dot center dot center dot) under barO)Me}(2)] (7) were obtained similarly from NiCl(2) and HL(3) and HL(4), respectively, in the presence of a base. The phosphinoenolate complex [Ni{(i-Pr)(2)PCH (center dot center dot center dot) under barC((center dot center dot center dot) under barO) Ph}(2)] (5) exists in ethanol as a mixture of the cis and trans isomers, in contrast to cis-[Ni{(Ph(2)PCH (center dot center dot center dot) under barC((center dot center dot center dot) under barO)Ph}(2)], and the solid-state structure of the trans isomer of 5 was established by X-ray diffraction. The structures of the ligand HL3 and of the complexes 1, 3 in 3 center dot 3/2CH(2)Cl(2), 4, 6 and 7 have also been determined by X-ray diffraction and are compared with those of related complexes. Complexes 4, 6 and 7 contain a five-membered heteroatomic metallocyclic moiety, which is constituted by five different chemical elements. The structural consequences of the steric bulk of the P substituents and of the electronic characteristics of the P, O chelates are discussed.

A series of cobalt(II) compounds of the type [CoX2(alpha-diimine)] were synthesised by direct reaction of anhydrous CoCl2 or CoI2 and the corresponding alpha-diimine ligand, in CH2Cl2: [CoI2(o,o',p-Me3C6H2-DAB)] ( 1), [ CoI2(o,o'-(Pr2C6H3)-Pr-i-DAB)] ( 2), ( where Ar-DAB = 1,4-bis(aryl)-2,3-dimethyl-1,4-diaza-1,3-butadiene), and [CoCl2(o,o',p-Me3C6H2- BIAN)] (3), [CoCl2(o,o'- (Pr2C6H3)-Pr-i-BIAN)] (4), and [CoI2(o,o'-(Pr2C6H3)-Pr-i-BIAN)] (5) (where Ar-BIAN = bis(aryl) acenaphthenequinonediimine). All compounds were characterised by elemental analyses, IR, mass spectrometry, and X-ray diffraction whenever possible. The crystal structures of compounds 2-4 showed, in all cases, distorted tetrahedral geometries about the Co, built by two halogen atoms and two nitrogen atoms of the alpha-diimine ligand. Compounds 3 and 4, as well as [ CoCl2(o,o',p-Me3C6H2-DAB)] (1a), and [ CoCl2( o,o'- (Pr2C6H3)-Pr-i- DAB)] (2a), were activated by methylaluminoxane (MAO) and tested as catalysts for ethylene polymerisation, showing low catalytic activities. Selected polyethylene ( PE) samples were characterised by H-1 and C-13 NMR and FT-IR spectroscopies, and by differential scanning calorimetry (DSC), revealing branching microstructures (2.5-5.5%). (c) 2007 Elsevier B. V. All rights reserved.