Teresa Avilés

New cationic mono-cyclopentadienyl complexes of Co(III) containing mono or bidentate nitrogen donor ligands of general formula [Co(eta (5)-C5H5)(PPh3)L-2][BF4](2) (L = NC-CH3, 2, and NC = Ph, 3) or [Co(eta (5)-C5H5)(PPh3)(L-L)[BF4](2), [L-L = 2,2 ' -bisimidazole (H(2)biim) (4) and dipyridylamine [HN(NC5H5)(2)] (5) have been synthesised by the stoichiometric reaction of the Co(III) complex Co(eta (5)-C5H5)(PPh3)I-2 (1), with Ag[BF4] and the appropriate ligand in CH2Cl2. Under the same conditions and using;trans-azobenzene as a ligand, an orthometalation reaction took placet giving the new compound [Co(eta (5)-C5H5)(PPh3)(kappa -C,kappa -N-C6H4N=NPh)][BF4] (6) in high yield. The structural characterisation of compounds 4 and 6, and of the starting compound Co(eta (5)-C5H5)(PPh3)I-2 (1) was done by single-crystal X-ray diffraction studies. DFT calculations (ADF program) were performed in order to understand the orthometallation reaction. (C) 2001 Elsevier Science B.V. All rights reserved.

The new compound [Co(eta(5)-C5H5)(dppf-P,P')I]I, 1, was synthesised by the stoichiometric reaction of the Co(III) complex [Co(eta(5)-C5H5)(CO)I-2], 2, with 1,1'-bis(diphenylphosphino)ferrocene (dppf) in CH2Cl2, and was characterised by multinuclear NMR spectroscopy. Exposure to air of THF or CH2Cl2 solutions of compound 1 gave, in an unexpected way, a polymeric chain comprising bridging 1,1'-bis(oxodiphenylphosphoranyl) ferrocene (dppfO(2)) joining tetrahedral Co(II) units [CoI2(mu-dppfO(2))](n), 3. Attempts to obtain the polymeric chain 3 by the direct reaction of dppfO(2) with CoI2, in CH2Cl2, gave instead the monomeric compound [CoI2(dppfO(2))], 4, in which dppfO2 is coordinated in a chelating mode. The structural characterisation of compounds 2, 3, and 4 was carried out by single crystal X-ray diffraction studies. The magnetic behaviour of [CoI2(dppfO(2))] and [CoI2(mu-dppfO(2))](n) was studied, and the results are consistent with tetrahedral S = 3/2 Co-II, possessing a (4)A(2) ground state, and S = 0 Fe-II. In these compounds, Co-II negative zero field splittings were determined from an analysis of the magnetic susceptibility temperature dependence, with D/k = -13 and -14 K for CoI2(dppfO(2)) and [CoI2(mu-dppfO(2))](n), respectively. DFT calculations were performed in order to understand the electronic structure of [Co(eta(5)-C5H5)(dppf-P,P')I]I, 1, as well as that of the paramagnetic specie [CoI2(dppfO(2))], 4. The [CoI2(mu-dppfO(2))](n) chain was also analysed and found to behave very similarly to the monomeric iodine derivative 4. The calculations showed the unpaired electrons to be localized on the Co(II) centre in all these species. The rather complicated electrochemical behaviour exhibited by the dppf complex [Co-III(eta(5)-C5H5)(dppf-P,P')I]I and by [Co(dppfO(2))I-2] is discussed.

The reactivity of arylisocyanates in supercritical carbon dioxide (scCO(2)) was studied using the easily available complexes CpCo(CO)(2), CpCoPPh3Me2 and Ni(cod)(2) as catalysts. A study of the solubility of the catalysts in scCO(2) was undertaken in all cases. The complex CpCo(CO)(2) is very soluble, 1.7 x 10(-1) mol kg(-1), while CpCoPPh3Me2 has a lower solubility, 7.2 x 10(-3) mol kg(-1), and Ni(cod)(2) is insoluble in scCO(2). For comparison purposes, the reactions were performed in parallel in scCO(2), using toluene as a solvent and just with the neat liquid arylisocyanate. Reactions in scCO(2) either do not take place at all, when CpCo(CO), is used as catalyst, or occur with low yields affording the trimer of the corresponding arylisocyanate when CpCoPPh3Me2 or Ni(cod)(2) act as catalysts. No incorporation of CO2 into the organic substrate was observed. Better conversions to triarylisocyanate were obtained when the reactions were performed by direct mixture of the liquid arylisocyanate ArNCO (Ar = Ph, p-CH3C6H4, p-CH3OC6H4) and the catalyst. Using toluene as a solvent, the yields of the trimers were lower than those obtained in neat arylisocyanate, and in some cases they were not formed at all. For instance in the reaction of CpCo(CO), and tolylisocyanate either under stoichiometric or catalytic conditions the trimer is not obtained, instead the compound H2R3N3C2O2 (R = CH3C6H4), was isolated in low yield. In the reaction of Ni(cod)(2)/PPh3 with phenylisocyanate, the trimer was formed but in low yield. The lower yields of the trimers observed when the reactions were performed in scCO(2) or in toluene, compared to that observed in neat arylisocyanates, indicates that the decrease in reactivity is due to a decrease in concentration. (C) 2001 Elsevier Science B.V. All rights reserved.

{Reaction of {[}Co(eta(5)-C5H5)(CO)(2)], 1, with 1,1'-bis(diphenylphosphino)ferrocene (dppf) yields the new trinuclear complex {[}Co(eta(5)-C5H5)(CO)](2)(mu-dppf), 2, which was structurally characterised by single crystal X-ray diffraction and showed two Co(eta(5)-C5H5)(CO) moieties covalently linked by a dppf bridge. Electrochemical studies in dichloromethane revealed that both Co(I) and Fe(II) in the precursors were oxidized to Co(II)/Co(III) and Fe(III), respectively. On the other hand, in 2 the two first oxidation waves were assigned to Co, the Fe(II) centre requiring a higher potential than in free dppf. DFT calculations showed that the HOMOs of 2 were localised in the Co fragments, owing to the destabilisation of the Co(eta(5)-C5H5)(CO) orbitals after binding dppf. (C) 2012 Elsevier B.V. All rights reserved.}

{A new rigid bidentate ligand, bis(1-naphthylimino)acenaphthene, L1, and its Zn(II) and Pd(II) complexes {[}ZnCl(2)(L1)], 1, and {[}PdCl(2)(L1)], 2, were synthesized. L1 was prepared by the ``template method{''}, reacting 1-naphthyl amine and acenaphthenequinone in the presence of ZnCl(2), giving 1, which was further demetallated. Reaction of 1-naphthyl amine with acenaphthenequinone and PdCl(2) afforded dichloride bis(1-naphthyl)acenaphthenequinonediimine palladium, 2. L1, 1, and 2 were obtained as a mixture of syn and anti isomers. Compound 2 was also obtained by the reaction of PdCl(2) activated by refluxing it in acetonitrile followed by the addition of L1; by this route also a mixture of syn and anti isomers was obtained, but at a different rate. The solid-state structures of L1 and the anti isomer of compound 2 have been determined by single-crystal X-ray diffraction. All compounds have been characterized by elemental analyses; matrix-assisted laser desorption ionization-time-of-flight-mass spectrometry; IR; UV-vis; (1)H, (13)C, and (1)H-(1)H correlation spectroscopy; (1)H-(13)C heteronuclear single quantum coherence; (1)H-(13)C heteronuclear single quantum coherence-total correlation spectroscopy; and (1)H-(1)H nuclear Overhauser effect spectrometry NMR spectroscopies when applied. Density functional theory studies showed that both conformers for {[}PdCl(2)(BIAN)] are isoenergetic, and they can both be obtained experimentally. However, we can predict that the isomerization process is not available in a square-planar complex, but it is possible for the free ligand. The molecular geometry is very similar in both isomers, and only different orientations for naphthyl groups can be expected.}

{Three new emissive 8-aminoquinoline derived probes (1)-(3) and one dinuclear Zn(II) complex (4) were synthesized and fully characterized. Their absorption spectra show maxima at 310-336 nm, and fluorescence emission between 456 and 498 nm. Compound (1) was characterized by single crystal X-ray diffraction. The effect upon Zn(II) and Cu(II) coordination to compounds (1)-(3) was studied by monitoring the changes in absorption and fluorescence spectra, and complemented by calculation of metal-ligand stability constants. The results indicate that compound (3) is the one that presents the most favorable geometry for coordinating two metal cations, fact that is confirmed by the synthesis of the dinuclear complex (4), with similar molecular geometry. (C) 2011 Elsevier B.V. All rights reserved.}

{{A series of cationic gold(I) alpha-diimine complexes of the type {[}(NHC)Au(alpha-diimine)]X or {[}(PPh(3))Au(alpha-diimine)]X, where NHC = IPr