Corneliu Cismasiu

Shock absorbers have been widely used in the automotive and aeronautical industries for many years. Inspired on these devices, the paper presents an analytical and numerical assessment of a high performance protective system for building structures against blast loads, which is composed of a shielding element connected to the main structure, at the floor levels, through ductile Energy Absorbing Connectors (EACs). The EACs exploit the external tube inversion mechanism to absorb a significant part of the imparted kinetic energy from the blast wave. While the system prototype has been developed in laboratory, it was characterized and tested in a full-scale blast testing campaign. A validated finite element model was used next to analyze its performance in a more demanding design scenario. The introduction of EACs notably reduces the peak horizontal loads and the kinetic energy transferred to the protected structure, being expected a significant reduction of the stresses in the supporting vertical elements, in addition to the protection of structural and non-structural members. These results encourage further studies of the presented protective system that can be potentially employed for a large variety of blast threat scenarios, especially when increasing the stand-off is not a possible/viable option and sensitive facilities have to be protected.

The present paper aims to examine the potential of the Applied Element Method (AEM) in simulating the blast effects in RC panels. The numerical estimates are compared with the results obtained in an experimental campaign designed to investigate the effectiveness of fibre grout for strengthening full scale RC panels by comparing the effects that a similar blast load produces in a reference and the strengthened panel. First, a numerical model of the reference specimen was created in the software Extreme Loading for Structures and calibrated to match the experimental results. With no further calibration, the fibre reinforced grout strengthening was added and the resulting numerical model subjected to the same blast load. The experimental blast effects on both reference and strengthened panels, despite the lack of high speed measurement equipment (pressure, strains and displacements sensors), compare well with the numerical estimates in terms of residual and maximum displacements, showing that, once calibrated, the AEM numerical models can be successfully used to simulate blast effects in RC panels.