Publications

Export 5 results:
Sort by: Author Title Type [ Year  (Desc)]
2021
Silva, Carlos, Jorge Martins, Jonas Deuermeier, Maria Elias Pereira, Ana Rovisco, Pedro Barquinha, João Goes, Rodrigo Martins, Elvira Fortunato, and Asal Kiazadeh. "{Towards Sustainable Crossbar Artificial Synapses with Zinc-Tin Oxide}." Electronic Materials. 2 (2021): 105-115. AbstractWebsite

In this article, characterization of fully patterned zinc-tin oxide (ZTO)-based memristive devices with feature sizes as small as 25 µm2 is presented. The devices are patterned via lift-off with a platinum bottom contact and a gold-titanium top contact. An on/off ratio of more than two orders of magnitude is obtained without the need for electroforming processes. Set operation is a current controlled process, whereas the reset is voltage dependent. The temperature dependency of the electrical characteristics reveals a bulk-dominated conduction mechanism for high resistance states. However, the charge transport at low resistance state is consistent with Schottky emission. Synaptic properties such as potentiation and depression cycles, with progressive increases and decreases in the conductance value under 50 successive pulses, are shown. This validates the potential use of ZTO memristive devices for a sustainable and energy-efficient brain-inspired deep neural network computation.

2020
Martins, Jorge, Asal Kiazadeh, Joana V. Pinto, Ana Rovisco, Tiago Gonçalves, Jonas Deuermeier, Eduardo Alves, Rodrigo Martins, Elvira Fortunato, and Pedro Barquinha. "{Ta2O5/SiO2 Multicomponent Dielectrics for Amorphous Oxide TFTs}." Electronic Materials. 2 (2020): 1-16. AbstractWebsite

Co-sputtering of SiO2 and high-$ąppa$ Ta2O5 was used to make multicomponent gate dielectric stacks for In-Ga-Zn-O thin-film transistors (IGZO TFTs) under an overall low thermal budget (T = 150 °C). Characterization of the multicomponent layers and of the TFTs working characteristics (employing them) was performed in terms of static performance, reliability, and stability to understand the role of the incorporation of the high-$ąppa$ material in the gate dielectric stack. It is shown that inherent disadvantages of the high-$ąppa$ material, such as poorer interface properties and poor gate insulation, can be counterbalanced by inclusion of SiO2 both mixed with Ta2O5 and as thin interfacial layers. A stack comprising a (Ta2O5)x(SiO2)100 − x film with x = 69 and a thin SiO2 film at the interface with IGZO resulted in the best performing TFTs, with field-effect mobility (µFE) ≈ 16 cm2·V−1·s−1, subthreshold slope (SS) ≈ 0.15 V/dec and on/off ratio exceeding 107. Anomalous Vth shifts were observed during positive gate bias stress (PGBS), followed by very slow recoveries (time constant exceeding 8 × 105 s), and analysis of the stress and recovery processes for the different gate dielectric stacks showed that the relevant mechanism is not dominated by the interfaces but seems to be related to the migration of charged species in the dielectric. The incorporation of additional SiO2 layers into the gate dielectric stack is shown to effectively counterbalance this anomalous shift. This multilayered gate dielectric stack approach is in line with both the large area and the flexible electronics needs, yielding reliable devices with performance suitable for successful integration on new electronic applications.

2017
Martins, Jorge, Pydi Bahubalindruni, Ana Rovisco, Asal Kiazadeh, Rodrigo Martins, Elvira Fortunato, and Pedro Barquinha. "{Bias Stress and Temperature Impact on InGaZnO TFTs and Circuits}." Materials. 10 (2017): 680. AbstractWebsite

This paper focuses on the analysis of InGaZnO thin-film transistors (TFTs) and circuits under the influence of different temperatures and bias stress, shedding light into their robustness when used in real-world applications. For temperature-dependent measurements, a temperature range of 15 to 85 • C was considered. In case of bias stress, both gate and drain bias were applied for 60 min. Though isolated transistors show a variation of drain current as high as 56% and 172% during bias voltage and temperature stress, the employed circuits were able to counteract it. Inverters and two-TFT current mirrors following simple circuit topologies showed a gain variation below 8%, while the improved robustness of a cascode current mirror design is proven by showing a gain variation less than 5%. The demonstration that the proper selection of TFT materials and circuit topologies results in robust operation of oxide electronics under different stress conditions and over a reasonable range of temperatures proves that the technology is suitable for applications such as smart food packaging and wearables.

2016
Bahubalindruni, Pydi Ganga, Asal Kiazadeh, Allegra Sacchetti, Jorge Martins, Ana Rovisco, Vitor Grade Tavares, Rodrigo Martins, Elvira Fortunato, and Pedro Barquinha. "{Influence of Channel Length Scaling on InGaZnO TFTs Characteristics: Unity Current-Gain Cutoff Frequency, Intrinsic Voltage-Gain, and On-Resistance}." Journal of Display Technology. 12 (2016): 515-518. AbstractWebsite
n/a
Kiazadeh, Asal, Henrique L. Gomes, Pedro Barquinha, Jorge Martins, Ana Rovisco, Joana V. Pinto, Rodrigo Martins, and Elvira Fortunato. "{Improving positive and negative bias illumination stress stability in parylene passivated IGZO transistors}." Applied Physics Letters. 109 (2016): 051606. AbstractWebsite
n/a