Rodrigo Martins

Highly transparent and conductive ZnO:Ga thin films were produced by rf magnetron sputtering at room temperature on polyethylene naphthalate substrates. The films present a good electrical and optical stability, surface uniformity and a very good adhesion to the polymeric substrates. The lowest resistivity obtained was 5×10-4 Ωcm with a sheet resistance of 15 Ω/sqr and an average optical transmittance in the visible part of the spectra of 80%. It was also shown that by passivating the polymeric surface with a thin SiO2 layer, the electrical and structural properties of the films are improved nearly by a factor of 2.

During the last years, oxide semiconductors have shown that they will have a key role in the future of electronics. In fact, several research groups have already presented working devices with remarkable electrical and optical properties based on these materials, mainly thin-film transistors (TFTs). Most of these TFTs use indium-tin oxide (ITO) as the material for source/drain electrodes. This paper focuses on the investigation of different materials to replace ITO in inverted-staggered TFTs based on gallium-indium-zinc oxide (GIZO) semiconductor. The analyzed electrode materials were indium-zinc oxide, Ti, Al, Mo, and Ti/Au, with each of these materials used in two different kinds of devices: one was annealed after GIZO channel deposition but prior to source/drain deposition, and the other was annealed at the end of device production. The results show an improvement on the electrical properties when the annealing is performed at the end (for instance, with Ti/Au electrodes, mobility rises from 19 to 25 cm2/V · s, and turn-on voltage drops from 4 to 2 V). Using time-of-flight secondary ion mass spectrometry (TOF-SIMS), we could confirm that some diffusion exists in the source/drain electrodes/ semiconductor interface, which is in close agreement with the obtained electrical properties. In addition to TOF-SIMS results for relevant elements, electrical characterization is presented for each kind of device, including the extraction of source/drain series resistances and TFT intrinsic parameters, such as VTi (intrinsic threshold voltage). © 2008 IEEE.

A quantitative study of the dynamics of threshold-voltage shifts with time in gallium-indium zinc oxide amorphous thin-film transistors is presented using standard analysis based on the stretched exponential relaxation. For devices using thermal silicon oxide as gate dielectric, the relaxation time is 3× 105 s at room temperature with activation energy of 0.68 eV. These transistors approach the stability of the amorphous silicon transistors. The threshold voltage shift is faster after water vapor exposure suggesting that the origin of this instability is charge trapping at residual-water-related trap sites. © 2009 American Institute of Physics.

The present work is focused on gelatin-based electrolytes doped with a range of concentration of zinc triflate (Zn(CF3SO3)2). The transparent-thin-film samples have been represented by the notation GelatinnZn(CF3SO3)2, where n represents the zinc triflate salt concentration in the electrolyte membranes from 0.00 wt% to 10.93 wt% The samples have been characterized by conductivity measurements, thermal analysis, cyclic voltammetry, X-ray diffraction (XRD), polarized optical microscopy (POM) and scanning electron microscopy (SEM). The gelatin-based electrolytes were also tested as ionic conductors in electrochromic devices with the glass/ITO/WO3/gelatin-based electrolyte/CeO2-TiO2/ITO/glass configuration. © 2013 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.

Tuberculosis (TB) remains one of the most serious infectious diseases in the world and the rate of new cases continues to increase. The development of cheap and simple methodologies capable of identifying TB causing agents belonging to the Mycobacterium tuberculosis Complex (MTBC), at point-of-need, in particular in resource-poor countries where the main TB epidemics are observed, is of paramount relevance for the timely and effective diagnosis and management of patients. TB molecular diagnostics, aimed at reducing the time of laboratory diagnostics from weeks to days, still require specialised technical personnel and labour intensive methods. Recent nanotechnology-based systems have been proposed to circumvent these limitations. Here, we report on a paper-based platform capable of integrating a previously developed Au-nanoprobe based MTBC detection assay - we call it "Gold on Paper". The Au-nanoprobe assay is processed and developed on a wax-printed microplate paper platform, allowing unequivocal identification of MTBC members and can be performed without specialised laboratory equipment. Upon integration of this Au-nanoprobe colorimetric assay onto the 384-microplate, differential colour scrutiny may be captured and analysed with a generic "smartphone" device. This strategy uses the mobile device to digitalise the intensity of the colour associated with each colorimetric assay, perform a Red Green Blue (RGB) analysis and transfer relevant information to an off-site lab, thus allowing for efficient diagnostics. Integration of the GPS location metadata of every test image may add a new dimension of information, allowing for real-time epidemiologic data on MTBC identification. © 2012 The Royal Society of Chemistry.

The model presented is based on the heat transfer and energy balance equations that rule the set of physical and chemical interactions that take place on the gas phase of a growth process, assuming that the deposition process occurs under laminar dynamic flow conditions (Knudsen number below 1). In these conditions, the chemistry and physics of the process involved in the growth mechanism of silicon thin films produced by the hot wire or the hot-wire plasma assisted technique can be proper derived by balance equations that supply information about how the plasma density, the gas dilution and the gas temperature influence the growth mechanism and the equilibrium of the concentration of species presented on the growth surface. The model developed establishes a relation between the abundance species formed and the parameters initiators of the process such as the filament temperature and the rf power density used.

This paper aims to characterize the growth process of polymorphous/ nanocrystalline silicon (pm-Si:H) films produced by PECVD at 13.56 MHz. The emphasis is in determining the plasma parameters that allow to control the conditions where pm/nc-Si:H can be obtained under high hydrogen dilution, where the only varied parameter is the silane gas flow, fixing rf power, deposition pressure and substrate temperature. The data achieved show that good pm/nc-Si:H films are produced at 240 Pa using a silane gas flow of 5sccm (dilution 1:70) to which it corresponds films with photosensitivities exceeding 106, optical gaps close to 1.80 eV and 18 at% hydrogen contents. The data also show that under certain deposition conditions the pm-Si:H films peel-off.

In this paper, we present results concerning the thickness dependence (from 70 to 890 nm) of electrical, structural, morphological and optical properties presented by gallium-doped zinc oxide (GZO) deposited on polyethylene naphthalate (PEN) substrates by r.f. magnetron sputtering at room temperature. For thicknesses higher than 300 nm an independent correlation between the electrical, morphological, structural and optical properties are observed. The lowest resistivity obtained was 5 × 10-4 Ω cm with a sheet resistance of 15 Ω/□ and an average optical transmittance in the visible part of the spectra of 80%. It is also shown that by passivating the surface of the polymer by depositing a thin silicon dioxide layer the electrical and structural properties of the films are improved nearly by a factor of two. © 2003 Elsevier B.V. All rights reserved.