Regina Monteiro

The present work investigates alumino-phosphate glasses from Li 2O-BaO-Al2O3-La2O3-P 2O5 system containing Sm3+ and Eu3+ ions, prepared by two different ways: a wet raw materials mixing route followed by evaporation and melt-quenching, and by remelting of shards. The linear thermal expansion coefficient measured by dilatometry is identical for both rare-earth-doped phosphate glasses. Comparatively to undoped phosphate glass the linear thermal expansion coefficient increases with 2 × 10-7 K-1 when dopants are added. The characteristic temperatures very slowly decrease but can be considered constant with atomic weight, atomic number and f electrons number of the doping ions in the case of Tg (vitreous transition temperature) and Tsr (high annealing temperature) but slowly increase in the case of Tir (low annealing temperature-strain point) and very slowly increase, being practically constant in the case of TD (dilatometric softening temperature). Comparatively to undoped phosphate glass the characteristic temperatures of Sm and Eu-doped glasses present lower values. The higher values of electrical conductance for both doped glasses, comparatively to usual soda-lime-silicate glass, indicate a slightly reduced stability against water. The viscosity measurements, showed a quasi-linear variation with temperature the mean square deviation (R 2) being ranged between 0.872% and 0.996%. The viscosity of doped glasses comparatively to the undoped one is lower at the same temperature. Thermogravimetric analysis did not show notable mass change for any of doped samples. DSC curves for both rare-earth-doped phosphate glasses, as bulk and powdered samples, showed Tg values in the range 435-450 C. Bulk samples exhibited a very weak exothermic peak at about 685 C, while powdered samples showed two weak exothermic peaks at about 555 C and 685 C due to devitrification of the glasses. Using designed melting and annealing programs, the doped glasses were improved regarding bubbles and cords content and strain elimination. © 2013 Elsevier B.V. All rights reserved.

Two glass compositions were prepared from the system SiO2-Li2O-K2O-ZrO2-P2O5 with different SiO2/Li2O ratio (2.39 and 3.39) and the crystallization behavior was investigated by differential thermal analysis (DTA), X-ray diffraction (XRD) and scanning electron microscopy (SEM). The crystallization kinetic parameters (activation energy of crystallization and Avrami exponent) were evaluated by different methods from the data obtained by DTA performed at different heating rates. For both glasses, two exothermic peaks were observed in the DTA curves, and the crystallization peak temperatures increased with SiO2/Li2O ratio. XRD analysis revealed that the first peak corresponds to the crystallization of lithium metasilicate (Li2SiO3) and the second to the formation of lithium disilicate (Li2Si2O5). After heating the glasses at a temperature above the second crystallization peak (900 °C), both Li2Si2O5 and Li2SiO3 were found in samples having the lowest SiO2/Li2O ratio, whereas no Li2SiO3 was detected in samples with the highest SiO2/Li2O ratio. For both glasses, the value obtained by different methods for the activation energy of crystallization was in the range of 225-275 kJ mol-1 for the first exothermic peak and in the range of 425-500 kJ mol-1 for the second peak. The estimated Avrami exponent was close to 1 for the first exothermic peak, indicating surface crystallization, and close to 3 for the second exothermic peak, suggesting volume crystallization. This was confirmed by the morphological study made by SEM that showed needle-like crystals in the microstructure of samples with lithium metasilicate and granular crystals in the microstructure of samples having lithium disilicate. © 2014 Elsevier Ltd and Techna Group S.r.l. All rights reserved.

The crystallization kinetics and phase transformation of a transparent Tb3+-doped lithium-aluminum phosphate glass, prepared by melt quenching, were investigated. The energy associated to the glass transition and the crystallization parameters (activation energy for crystallization and Avrami exponent) were evaluated by different methods using the experimental data obtained by differential thermal analysis performed at different heating rates. Using an isoconversional method to determine the change of the activation energy for crystallization with the fraction of crystallization, it was verified that with the increase in the fraction of crystallization from 0.1 to 0.9, the value of the activation energy decreased slightly from  370 to  310 kJ mol -1 and that the Avrami exponent varied from 0.8 to 1, suggesting a surface crystal growth mechanism. Observation of the microstructural evolution of heat-treated glass samples confirmed a surface crystallization process revealing spherulitic crystals constituted mainly by aluminum metaphosphate. © 2014 Springer Science+Business Media New York.

A transparent Eu3 +-doped lithium aluminophosphate glass was prepared by melt-quenching technique. The thermal behavior of the glass was investigated by differential thermal analysis (DTA), the structure was studied by X-ray diffraction (XRD) and the morphology was observed by optical polarization microscopy and scanning electron microscopy (SEM). The activation energy of glass transition and the activation energy of crystallization and Avrami exponent have been evaluated under non-isothermal conditions from the data obtained by DTA at different heating rates. DTA curves exhibited an endothermic peak associated with the glass transition and two exothermic peaks. The mean value calculated for the activation energy of glass transition was 545 kJ mol- 1. The activation energy of crystallization was   400 kJ mol- 1 for the first exothermic peak and   170 kJ mol- 1 for the second peak. The Avrami exponent was   1 for both peaks indicating surface crystallization. XRD results showed that the main crystalline phase, aluminum metaphosphate, Al(PO3)3, and aluminum phosphate, AlPO4, were formed together with lithium barium phosphate, Li 3Ba(PO3)7, during the first exothermic peak and together with barium pyrophosphate, Ba2P2O7, during the second peak. Morphological study of heat-treated glass samples revealed microstructural features that confirmed a surface crystallization process. © 2014 Elsevier B.V.