Hugo C. Biscaia

Externally bonded fiber-reinforced polymer (FRP) composites have been widely used for the strengthening and repairing of reinforced concrete (RC) beams. Existing studies have denstrated that the full-range behavior and the associated debonding mechanism of the FRP-to-concrete interface between two adjacent cracks in the FRP-plated RC beam are different from those of the pull-off bonded joint. Moreover, the bond behavior between the FRP and the concrete may be affected by interfacial thermal stresses induced by the service temperature variations (i.e., the thermal loadings). Based on a fully reversible bilinear bond-slip model, this paper presents an analytical study to investigate the full-range deformation behavior of the FRP-to-concrete interface between two adjacent cracks under combined mechanical and thermal loadings. The analytical results have indicated that the thermal loadings may significantly influence the full-range deformation behavior and the axial stress distribution of the FRP plate, although the material properties of concrete, adhesive, and FRP are assumed to be not affected by the service temperature variations. A temperature increase leads to an increase in the ultimate load of the bond interface and vice versa. A finite element (FE) model with different considerations of the bondline damage is developed to verify the proposed analytical solution. The reliability of the proposed analytical solution is then validated by the comparisons between the analytical results and the corresponding predictions provided by the FE model. © 2022 Elsevier Ltd

This study aims to mitigate the gap of knowledge on the cyclic bond behaviour of Carbon Fiber Reinforced Polymer (CFRP) bonded onto a steel substrate. The Distinct Element Method was used to model different bonding techniques such asExternally Bonded Reinforcement (for reference purposes); the linear increase of the width of the CFRP composite; theassumption of a mixed adhesive; and using an additional steel plate bonded on the top of the CFRP. Compared with themonotonic loading simulations, the load capacity and ductility of the joints with the lowest overlapped bonded lengths decreasedwith the number of cycles. However, the strength of the CFRP-to-steel joints was not affected if the overlapping bonded joint hada long length © 2022. Published by Shahid Chamran University of Ahvaz