António Manuel Pinho Ramos

n/a

n/a

n/a

n/a

n/a

Flat slab structures are a very common structural solution nowadays, due to their architectural and economic advantages. However, flat slab-column connections may be vulnerable to punching failure, especially in an event of an earthquake, with potentially high human and economic losses. This type of structural solution is adequately covered by design codes and recommendations in North America, due to a large amount of experimental research carried out. In Europe the situation is different, missing specific guidance to flat slab design under earthquake action in most European codes. The ACI 318-14 prescriptive approach to the gravity shear ratio-drift ratio relationship shows good agreement with experimental results. Following a similar approach and, based in a databank containing cyclic horizontally loaded tests of slab-column connections found in literature, proposals are made applicable to EC2 and MC2010.

The progressive collapse of structures generally results in the loss of human lives. Experience shows that flat slab structures are very sensitive to progressive collapse, which may cause serious accidents if special detailing is not provided. The post-punching behaviour of a column-supported slab is decisive in the progressive collapse development. This work presents the experimental research carried out to study the post-punching behaviour of prestressed concrete flat slabs. Six reduced-scale prestressed concrete flat slab models were tested. The tests were carried out in two different phases. In the first phase the models were loaded up to failure by punching. Afterwards, the models were loaded again to study the post-punching behaviour changes caused by the presence of unbonded, prestressed tendons and the influences of their distance to the column.

n/a

n/a

The present work reports experimental research carried out on repair and strengthening methods of flat slabs for punching. The repair and strengthening methods studied are: strengthening using transversal prestress, repair by substitution of the damaged concrete; and strengthening using steel beams as a column head, connected to the column and to the slab with epoxy resin and mechanical expansion anchors. Four experimental test slabs (AR1 to AR4) were produced and tested: two with transversal prestress, one only repaired and one strengthened with a steel column head. The execution process, its efficiency and design, are discussed.

n/a

n/a

n/a

n/a

The experimental analysis of nine prestressed flat slab models under punching is described and the results are compared with the recommendations of EC2 and MC90. The tests were performed on specimens at a scale 1/3, prestressed with unbonded high strength steel. In the first set, the specimens (AR2 to AR5 and AR7) were only subjected to in-plane compression, to evaluate the effect of the in-plane forces on the punching resistance. The second set of tests (AR8 to AR11) intended to study the effect of the vertical component of the tendon forces near the column in the punching resistance. This work aims to improve the understanding of the behaviour of prestressed flat slabs under punching load and the evaluation of the punching resistance.